Description
Right front window regulator motor for PEUGEOT 307. Without folding mirror function. Not suitable for CC convertible.
This electric window motor is designed as a direct-fit replacement for the right front door of Peugeot 307 models. It operates the window regulator mechanism to raise and lower the glass smoothly and reliably. The unit is compatible with many OE references used on Peugeot 307 (both 307 I and 307 II), but it does not provide any folding-mirror functionality and must not be used on CC convertible variants.
Technical Information
- Manufacturer: Stellantis (Peugeot/Citroën)
- Model: Peugeot 307 (Right Front)
- Product Codes: 9634457480, 9222N3, NFP
- Additional Numbers: 9222N3 | 9634457480
Compatibility
Fits Peugeot 307 right front door applications. Not suitable for CC convertible models. Often searched and ordered by product codes 9634457480 or 9222N3 — include these codes when looking up fitment.
Installation Recommendations
- Disconnect the negative battery terminal before starting work to avoid electrical shorts and to protect door electronics.
- Remove the door trim panel and peel back the moisture barrier carefully to access the regulator and motor assembly.
- Support the glass in its fully up position with tape or a suitable clamp before unbolting the motor or regulator to prevent glass damage.
- Unplug the electrical connector, remove the motor mounting bolts, and detach the motor from the regulator. Transfer any necessary clips or rollers to the new motor if applicable.
- Install the new motor, reconnect the electrical connector, briefly reconnect the battery to test full up/down operation before reassembling the door trim.
- Reassemble the moisture barrier and door card, ensuring all fasteners and trim clips are correctly refitted.
Common Reasons For Failure
- Water Ingress: Door seals or moisture barriers damaged or misaligned allow water to reach the motor, causing corrosion and electrical failure.
- Mechanical Wear: Internal gears, brushes or gearboxes wear over time, especially on high-use vehicles, leading to intermittent or complete failure.
- Regulator Issues: A seized or misaligned regulator increases load on the motor and shortens its service life.
- Corroded Connectors: Poor electrical contact from corroded plugs or wiring can cause erratic operation or no operation.
Practical Notes
This part is commonly ordered by its product numbers 9634457480 and 9222N3, so including these codes in search or order fields speeds up identification. Replacement is routine for an experienced mechanic and typically takes between 30 and 90 minutes depending on door trim complexity and workshop setup. Always verify smooth glass movement and correct alignment after installation to avoid premature wear.
If you are a DIY enthusiast, follow the safety steps above, take photos during disassembly to help reassembly, and test the unit before final trim refit. For vehicles with central locking or alarmed doors, be mindful of door electronics when disconnecting the battery.
