Description
Rear right fender lamp for Citroën C4 Picasso. Passenger side.
This used OEM rear right fender lamp is a direct replacement for Citroën C4 Picasso and compatible Grand Picasso models. Designed for mechanics and experienced DIY enthusiasts, the unit restores rear lighting functions (position, stop and turn signal; depending on vehicle variant may also include reversing or fog light functions). Supplied with original part references 9653547480 / 6351CA for easy lookup in parts catalogs and service lists. Ideal when the original lamp is cracked, water damaged or its electrical contacts have corroded.
Key Features
- Direct Fit For Citroën C4 Picasso / C4 Grand Picasso (Passenger Side, Rear Right)
- OEM Reference Numbers: 9653547480, 6351CA
- Restores Full Rear Lighting Functions: Position, Brake And Turn Signal (Variant Dependent)
- Suitable For Professional Workshops And Competent DIY Repairs
Technical Information
- Manufacturer: Citroën (Stellantis)
- Model: Citroën C4 Picasso; Citroën C4 Grand Picasso
- Product Codes: 9653547480, 6351CA
- Additional Numbers: NFP (as referenced in supplier listing)
Installation Recommendation
- Preparation: Switch Off Ignition And Remove Key. For added safety, disconnect The Negative Battery Terminal If You Will Work On Wiring.
- Access: Open The Tailgate/Boot Lining Or Remove Interior Trim Panels To Reach The Fender Lamp Fasteners.
- Removal: Unscrew Fasteners, Release Clips And Carefully Pull The Lamp Assembly Out Of The Fender. Unplug The Electrical Connector And Remove Any Retained Bulbs Or Sockets If Necessary.
- Fitment: Check Mounting Points And Seals. Connect The Electrical Plug, Position The Lamp Into The Fender, Reinstall Fasteners And Replace Trim. Ensure Gaskets Or Seals Sit Correctly To Prevent Water Ingress.
- Testing: Before Final Assembly, Test All Lighting Functions (Position, Brake, Indicator, Reverse/Fog If Present). Align The Lamp And Recheck Seals After A Short Test Drive.
- Estimated Time: Approximately 30–60 Minutes Depending On Access And Whether Interior Trim Must Be Removed.
Why This Part Fails Most Often
- Water Ingress And Moisture Sealing Failure Leading To Corrosion Of Contacts Or Internal Electronics.
- Impact Damage From Minor Collisions Or Parking Scrapes Causing Cracks In The Lens Or Mounting Tabs.
- Connector And Pin Corrosion Due To Road Salt Or Poor Sealing.
- Bulb Burnout Or, In Some Variants, LED Module Degradation Over Time.
Fitment And Replacement Notes
Confirm That The Vehicle Uses The Same Connector Shape And Mounting Points As The Supplied Unit. When Replacing, Inspect Wiring, Sockets And Gaskets; Replace Any Damaged Fasteners Or Seals To Avoid Repeat Failures. For Professional Installations, Use Correct Torque For Fasteners And Ensure Proper Alignment To Prevent Water Trapping.
