Description
Bulb socket for right rear lamp for Peugeot 308 Hatchback. Supplied with a piece of wiring – without sealing rubber.
Product Overview
Direct replacement bulb socket designed for the right-hand rear lamp of the Peugeot 308 Hatchback. Ideal for mechanics and DIY enthusiasts who need a reliable electrical connection for P21/5W dual-filament brake/taillight bulbs. The part is supplied with a short section of wiring but does not include the sealing grommet, so attention to the lamp housing seal is required during installation.
Key Features
- Direct Fit For Peugeot 308 Hatchback Rear Right Lamp
- Designed For Bulb Type: P21/5W (Brake / Tail)
- Supplied With Wiring Section For Easy Replacement
- Simple Plug-In Socket, Compatible With Standard Lamp Assemblies
Technical Information
- Manufacturer: Stellantis (Peugeot/Citroën)
- Model: Peugeot 308 Hatchback
- Product Codes: 1606959180
- Other Numbers: Bulb Type P21/5W
Installation Recommendation
- Park Vehicle Safely And Switch Off Ignition. For Safety, Disconnect The Negative Battery Terminal If You Will Be Working On The Vehicle Wiring.
- Open The Boot And Remove Any Interior Trim Panels Or Fasteners To Access The Rear Lamp Assembly.
- Unscrew Or Unclip The Lamp Assembly From The Body And Carefully Pull It Out To Expose The Bulb Socket.
- Disconnect The Old Socket From The Wiring Harness And Remove The Bulb By Turning/Withdrawing As Required.
- Install The New Socket: Connect The Wiring Section, Insert The Bulb, And Ensure The Electrical Contacts Are Clean And Secure.
- Because This Part Is Supplied Without The Sealing Rubber, Fit A New Grommet Or Ensure The Lamp Housing Seal Is Intact To Prevent Water Ingress.
- Reinstall The Lamp Assembly, Refit Interior Trim, Reconnect The Battery If Disconnected, And Test All Lighting Functions (Tail, Brake, Indicator If Applicable).
Why This Part Fails Most Often
Bulb sockets in rear lamps are subject to heat, vibration, moisture, and oxidation, which are the primary causes of failure. Typical failure modes include:
- Corroded Or Pitted Contacts Causing Intermittent Or No Connection.
- Melted Or Deformed Plastic From Overheating (Often Caused By Poor Contact Or High Resistance At The Connector).
- Water Ingress When The Sealing Grommet Is Missing Or Damaged, Leading To Short Circuits Or Corrosion.
- Damaged Wiring From Mechanical Stress Or Rodent Activity.
With normal use, a socket can last many years; failures are more common in vehicles exposed to damp environments, salt, or frequent vibration.
Additional Notes
- Because This Item Does Not Include The Sealing Rubber, Replace The Grommet Or Verify The Lamp Housing Seal To Avoid Moisture Problems.
- Use Clean Bulb Contacts And Correct Bulb Type (P21/5W) To Prevent Overheating And Premature Wear.
- If You Encounter Repeated Contact Failures, Inspect The Wiring And Ground Connections For Corrosion Or Damage.
