Description
Seat Belt Buckle Holder For Citroën C3 II (A51)
Front Driver And Passenger Seat
Finish FXX – Black
This seat belt buckle holder is designed for the Citroën C3 II (A51) and secures the buckle assembly for the front driver and passenger seats. It provides a direct replacement for damaged or worn bracketry and restores correct buckle positioning for safe and comfortable belt use. Commonly searched by part numbers 9687393180 and 8975SY, this durable FXX black finish bracket fits the original mounting points and matches the interior trim.
Function And Fitment
The holder secures the seat belt buckle to the seat structure, ensuring the buckle is correctly positioned and stable during normal use and in the event of a collision. It is intended for front seats (driver and passenger) on Citroën C3 II (A51) models. The part locates to the seat frame using factory mounting points and is compatible with the standard buckle assemblies used on these models.
Mounting Recommendations
- Before starting work, follow standard safety procedures. If the vehicle is equipped with seat belt pretensioners or airbags, disconnect the battery and wait the manufacturer-recommended time to avoid accidental deployment.
- Slide the seat fully back (or forward) to gain access to the mounting area, then remove any trim panels covering the seat base.
- Unbolt the old holder from the seat frame (typically Torx/hex bolts). Keep original fasteners if they are undamaged; replace corroded or deformed bolts with equivalent grade fasteners.
- Transfer the buckle assembly to the new holder if required, then fit the new bracket to the seat frame and torque fasteners to the vehicle manufacturer specification.
- Reinstall trim panels and check buckle function: the latch should engage smoothly and return to the upright position without binding.
- Perform a final visual inspection and, if battery was disconnected, reconnect and check that any seatbelt warning or airbag indicators behave normally.
Why This Part Typically Fails
Failure of the buckle holder usually results from mechanical damage (e.g., impact in a collision), plastic fatigue or embrittlement from long-term exposure, heavy or improper use, or corrosion of mounting hardware. Accidental loads, knocks when entering/exiting the vehicle, and wear from repeated buckle insertion can also deform or crack the bracket. Replacing a compromised holder is important because a loose or misaligned buckle can reduce the effectiveness of the restraint system.
Technical Information
- Manufacturer: Stellantis (Citroën)
- Model: Citroën C3 II (A51) – Front Driver And Passenger Seat
- Product Codes: 9687393180
- Other Numbers: 8975SY
Notes For Mechanics And DIY Enthusiasts
When fitting this part, ensure correct alignment to avoid stress on the buckle or cable routing. Use appropriate tools and replacement fasteners if original bolts show signs of corrosion. After installation, verify buckle engagement and seat belt retraction. If the vehicle has pretensioners or related safety systems, consider inspection by a qualified technician to confirm system integrity following any incident that damaged the original bracket.
