Description
Seat Belt Bracket For PEUGEOT 308 T7 Passenger Seat
Product Overview
This seat belt bracket / buckle holder is designed for the passenger seat of the Peugeot 308 T7. It is a direct-fit component intended to restore correct seat belt positioning and secure latching on the passenger side. Commonly searched under OE code 8975K9, this part is suitable for professional workshops and experienced DIY technicians who perform interior and safety-related repairs.
Why Choose This Part
Replacing a worn or damaged seat belt bracket ensures reliable buckle engagement and maintains occupant safety. The part fits original mounting points and is a practical choice when the original bracket is bent, corroded or the buckle receiver is loose. Keeping the original geometry and mounting integrity is essential for proper seat belt function.
How It Is Replaced
Replacement should be performed by a qualified technician or an experienced DIYer familiar with vehicle safety systems. Typical steps include:
- Remove interior trim panels around the seat and B-pillar as required to access mounting bolts.
- Unbolt the existing bracket from its mounting points. Retain or replace fasteners according to condition and manufacturer guidance.
- Transfer any sensors, wiring clips or trim guides from the old bracket to the new one.
- Install the new bracket, tighten bolts to the manufacturer’s torque specifications and verify correct alignment of the buckle receiver.
- Check seat belt latch engagement and reassemble trim. Verify that no warning lights or faults are present and confirm the belt retracts and latches smoothly.
Installation Recommendations
- Always Disconnect The Battery Before Starting Work On Seat Belt Or Airbag-Related Components To Prevent Accidental Deployment.
- Use Correct Torque Values For Mounting Bolts; Refer To The Vehicle Service Manual For Exact Specifications.
- Inspect Fasteners And Replace Corroded Or Stretched Bolts; Do Not Reuse Damaged Fixings.
- Ensure All Wiring Clips And Trim Are Reinstalled To Avoid Rubbing Or Pinching Of Cables.
- If The Vehicle Has Been Involved In A Collision, Replace Pretensioners And Any Airbag-Related Components Following Manufacturer Guidelines.
Reasons For Failure
Seat belt brackets typically fail or require replacement for the following reasons:
- Accident Damage Or Impact Leading To Bent Or Cracked Bracket Geometry.
- Corrosion From Moisture, Road Salt Or Long-Term Exposure, Weakening The Mounting Points.
- Wear Or Damage To The Buckle Receiver Causing Poor Latching Or Intermittent Release.
- Loose Or Missing Mounting Bolts Causing Movement And Incorrect Belt Positioning.
- Incorrect Previous Repairs Or Improper Installation.
Technical Information
- Manufacturer: Peugeot / Stellantis
- Model: 308 T7 (Passenger Seat)
- Product Codes: 8975K9
- Other Numbers: 8975.K9
Compatibility And Notes
Intended For: Passenger Side Of Peugeot 308 T7. Verify Visual Match With Existing Part Before Installation. This component is focused on mechanical mounting and buckle reception; if the vehicle reports belt-system faults after replacement, further diagnosis of pretensioners, sensors and control modules may be required.
Final Advice
Keep Safety A Priority: Work Carefully Around Seat Belt And Airbag Systems. If You Are Unsure About Any Step, Consult A Professional Workshop Or The Vehicle Service Manual To Ensure Correct And Safe Installation.
