Description
Right rear passenger seat belt for Peugeot 206 206+ Color FXX – Black
Product Overview
High-quality right rear passenger seat belt suitable for Peugeot 206 and Peugeot 206+. Supplied in Color FXX (Black). This replacement belt is commonly searched and identified by OEM product codes, making it easy for mechanics and DIY enthusiasts to find the correct part quickly. Ideal for restoring occupant safety after wear, damage or pretensioner deployment.
Technical Information
- Manufacturer: Stellantis Citroen Peugeot
- Model: Peugeot 206, Peugeot 206+
- Product Codes: 96544968XX, 8975QZ, 8975R0
- Other Numbers: 8975.QZ, 8975.R0, 8975QZ, 8975R0, 96544968XX, T50/M10
Function And Features
The seat belt assembly secures the rear right passenger during a collision or sudden deceleration. If equipped with a pyrotechnic pretensioner (pyro), the device tightens the belt instantly at the moment of impact to reduce occupant movement. The assembly includes webbing, retractor with inertia locking mechanism, anchor points and pretensioner when applicable.
How The Part Is Replaced
- Park vehicle on level ground and disconnect the negative battery terminal. Wait at least 10 minutes to discharge residual power in the restraint system before starting work.
- Remove interior trim panels to access the retractor and anchor bolts. Keep trim clips safe for reuse.
- Unbolt the lower anchor and retractor. Common fastener types indicated by tags: Torx T50 head and M10 thread anchors.
- Disconnect any electrical connector for a pretensioner (if fitted) before removal. Handle pretensioner wiring with care—do not expose to sparks or open flame.
- Install new belt assembly ensuring correct routing of webbing and that the retractor is mounted in the original orientation. Reuse or replace fasteners as required and tighten to manufacturer torque specifications.
- Reassemble trim panels and reconnect the battery. Perform a function check: belt extends and retracts smoothly and the locking mechanism engages under a sharp pull.
Installation Recommendations
- Always disconnect the battery and wait before starting work to avoid accidental pretensioner deployment or airbag faults.
- Observe correct routing and orientation of the webbing to ensure proper function of the retractor and locking mechanism.
- Replace any damaged trim clips or corroded fasteners; use correct replacement bolts (Torx/M10 where applicable).
- If the pretensioner has deployed in an accident, replace the entire seat belt assembly—pretensioners are single-use devices and cannot be reset.
- After installation, confirm that the belt retracts freely, locks under sharp pull and that there are no twists in the webbing.
Most Common Reasons For Failure
- Wear and Abrasion: Webbing frays or weakens over time from repeated use, sharp edges or contamination.
- Retractor Fault: Inertia locking mechanism can seize or lose tension due to dirt, corrosion or mechanical failure.
- Pretensioner Deployment: Pyrotechnic pretensioners activate in a collision and must be replaced afterward.
- Corroded Or Damaged Fasteners: Anchor bolts exposed to moisture can corrode, reducing attachment integrity.
- Accidental Damage: Cuts, burns or chemical contamination compromise webbing strength and require replacement.
Additional Notes
This part is often searched by its product numbers (96544968XX, 8975QZ, 8975R0). Suitable for professional workshops and competent DIY mechanics familiar with vehicle restraint systems. If the vehicle is equipped with a pretensioner, treat components with appropriate caution and follow manufacturer procedures for safe replacement.
