Description
Right front wiper motor for Peugeot 3008 and 5008 first generation. Passenger side.
This used right front wiper motor is a direct-fit unit for first-generation Peugeot 3008 and 5008 models, commonly referenced under part numbers 9671062380, 3397021289, 6405PX, 6405PY and 6405PA. It replaces the motor that drives the passenger-side windshield wiper arm and is suitable for mechanics and competent DIYers who need a reliable replacement part to restore correct wiper function.
Key Features And Benefits
- Direct Fit For Original Mounting Points: Designed to match the factory attachment and linkage geometry for straightforward replacement.
- Multiple OEM Cross References: Supplied with commonly used Peugeot/Stellantis part numbers to simplify identification and ordering.
- Practical For Workshop Use: Ideal for professional workshops and experienced home mechanics carrying out scheduled or corrective repairs.
- Cost-Effective Repair Option: Restores wiping performance without the expense of full linkage replacement when motor is the faulty component.
Compatibility
Compatible With: Peugeot 3008 I; Peugeot 5008 I (Passenger/Right Front Wiper). Check listed product codes to confirm fit with your vehicle’s existing motor and linkage arrangement.
Installation Recommendations
- Safety First: Disconnect the vehicle battery before starting work to prevent short circuits and accidental motor activation.
- Tools Required: Torx/Spline Sockets, Ratchet, Screwdrivers, Pliers, Trim Removal Tools, Multimeter for quick electrical checks.
- Basic Replacement Steps: Remove the wiper arm (mark position if necessary), detach cowl or access panel, disconnect electrical connector, unbolt the motor from the linkage/housing, replace with the new unit and refit linkage and seals. Reconnect electrical plug, refit cowl and wiper arm, then test park and sweep positions under power.
- Alignment Tip: Ensure the wiper arm is set to the correct park position before fully tightening. Verify smooth, full-range movement and correct park position during initial test.
- Torque And Fixings: Use correct torque for mounting fasteners per workshop manual where available; avoid over-tightening plastic fasteners.
Reasons Why The Part Commonly Fails
- Water Ingress And Corrosion: Moisture penetrating seals leads to corrosion of gears, motor brushes and electrical contacts.
- Mechanical Wear: Internal gear wear and degraded brushes cause loss of torque or intermittent operation after years of use.
- Linkage Seizure Or Excessive Load: Frozen or misaligned wiper linkage increases motor load and can lead to premature failure.
- Electrical Faults: Connector corrosion, broken wires or poor grounds cause intermittent or no operation.
- Environmental Stress: Salt, road debris and heavy use accelerate wear and reduce service life.
Technical Information
- Manufacturer: Stellantis (Citroën / Peugeot)
- Model: Peugeot 3008 I; Peugeot 5008 I
- Product Codes: 9671062380; 3397021289; 6405PX; 6405PY; 6405PA
- Additional Numbers: 6405PX / 6405PA / 6405PY (Common Cross References)
Practical Notes For Mechanics
Before replacement, verify whether the fault is electrical (check fuse, connector and voltage at the motor) or mechanical (hand-check linkage for free movement). When replacing only the motor, inspect the linkage and pivot bushes for play; worn linkage parts will quickly wear the new motor. After installation, perform several wipe cycles to ensure correct operation and park position.
