Description
Speaker for Citroën and Peugeot vehicles. Diameter 165 mm.
High-quality replacement speaker designed for a range of Citroën and Peugeot models. Ideal for professional mechanics and experienced DIY enthusiasts looking to restore factory audio performance or upgrade worn door speakers. This 165 mm driver matches original equipment dimensions and mounting points, making installation straightforward on compatible vehicles. Commonly searched by product codes 9664955980 and 6562X3, the speaker is suitable as a direct replacement in many OE locations where a 165 mm unit is used.
Technical Information
- Manufacturer: Stellantis (Citroën/Peugeot)
- Model: Compatible with selected Citroën and Peugeot models (see list below)
- Product Codes: 9664955980, 6562X3, 6562.X3
- Other Numbers: 6562.X3 (alternate notation)
- Diameter: 165 mm
Compatible Models (Examples)
Citroën C3 Picasso, Citroën C4 Picasso, Citroën C5 (X7), Peugeot 207, Peugeot 407. Check the listed models and product codes when searching; the part is often referenced by the OE number in spare-part searches.
Function and Typical Failure Modes
The speaker reproduces midrange and low-mid frequencies in the vehicle audio system and is usually mounted in doors, rear shelves, or front panels depending on the model. Over time the most common causes of failure are:
- Mechanical damage to the cone or surround from impact or improper removal.
- Voice coil overheating or burning caused by prolonged clipping or amplifier faults.
- Moisture ingress leading to corrosion of terminals, magnet, or damage to the cone and spider.
- Connector corrosion or broken wiring in door harnesses due to repeated door movement.
Replacement Interval
Speakers do not have a fixed service interval. Under normal conditions they often last many years; typical life expectancy is multiple years to over a decade depending on usage, exposure to moisture, and audio power. Replace if you detect distortion, rattling, loss of output, or physical damage.
Mounting Recommendations
- Prepare tools: trim tools, screwdriver set, and a multimeter for quick checks.
- Before beginning, disconnect the negative battery terminal to avoid accidental short circuits and to protect vehicle electronics when working near door modules.
- Carefully remove the interior trim or door card following the vehicle manufacturer’s procedure to avoid breaking plastic clips.
- Unscrew the old speaker, unplug the electrical connector and detach the speaker from the mounting cup or bracket.
- Compare the new speaker with the old one: verify cone diameter (165 mm), mounting hole pattern, and connector type. Check installation depth clearance inside the door panel.
- Install the new speaker, ensuring correct polarity of the wiring (observe + and – marks) to maintain proper phase with the rest of the system.
- Tighten mounting screws securely but avoid over-torquing plastic parts. Reconnect wiring and test the speaker at low volume before final reassembly.
- Reinstall the trim, ensuring all clips and fasteners are correctly engaged.
Tips for a Reliable Installation
- Inspect wiring and connectors for corrosion or broken crimp pins; replace or repair connectors if needed.
- Seal around speaker openings if moisture is a concern; use foam gasket or appropriate sealant to avoid rattles and water intrusion.
- If the vehicle has an amplifier or active crossover, verify impedance and power handling compatibility before connecting.
- Test audio at low volume first to ensure no distortion; gradually increase to check for proper operation.
Why This Part Fails Most Often
Failure is most frequently caused by environmental exposure (moisture and dirt), physical damage during door work, and electrical stress from poor amplifier settings or clipping. Regular inspection during door repairs and ensuring correct installation reduce premature failures.
Keywords
Citroën Speaker, Peugeot Speaker, 165 mm Speaker, 9664955980, 6562X3, Door Speaker Replacement, OE Fit Speaker
