Description
Accelerator pedal for PEUGEOT 307 and 307 CC. Also suitable for Citroën C4.
Overview
High-quality accelerator (throttle) pedal assembly with integrated position sensor for drive-by-wire systems. Manufactured by Bosch and listed under multiple OEM references, this pedal is a direct-fit replacement on many Stellantis models. Frequently searched by part numbers such as 0280755081 or 9680566080, it is intended for professional workshops and experienced DIY mechanics who repair modern electronic throttle systems.
Technical Information
- Manufacturer: Bosch
- Model: Peugeot 307, Peugeot 307 CC, Citroën C4
- Product Codes: 0280755081, 9680566080, 1601T7
- Additional Numbers: 280755081, 1601 T7, NFP
Fitment
Designed as a replacement for vehicles equipped with electronic throttle control that carry the above OEM or Bosch references. Always match the part number printed on the original pedal to ensure correct fitment and connector compatibility. This unit commonly fits Peugeot 307 range including CC variants and some Citroën C4 configurations.
Function
The accelerator pedal assembly contains a position sensor (potentiometer or hall-effect sensor) that measures driver throttle demand and transmits an electrical signal to the engine control unit (ECU). In drive-by-wire systems the ECU interprets this signal to control throttle opening, engine torque and cruise functions. Proper sensor output is essential for smooth throttle response and emission control.
Replacement Procedure
- Disconnect the vehicle battery before starting work to protect electronic components.
- Remove the lower dash trim or footwell cover to access the pedal assembly.
- Unplug the electrical connector and inspect for corrosion or bent pins.
- Remove the mounting bolts securing the pedal to the bracket and extract the old unit.
- Install the new pedal, tighten fasteners to the manufacturer’s torque specification, and reconnect the connector.
- Reconnect the battery and perform any required throttle relearn or calibration procedure according to the vehicle manufacturer’s instructions.
Installation Recommendations
- Always disconnect the battery when working on electronic components.
- Inspect wiring harness and connector for damage or corrosion; repair any faults before installation.
- Ensure mounting surfaces are clean and that the pedal moves freely without binding.
- Use correct torque values for mounting bolts and avoid overtightening plastic components.
- After installation, clear any stored fault codes and verify throttle response and idle stability. If the vehicle requires coding or calibration, use appropriate diagnostic equipment.
Common Failure Causes
- Wear of the internal position sensor (potentiometer or electronic sensor) leading to erratic signal output.
- Moisture ingress or corrosion in the connector or sensor electronics.
- Mechanical damage from impact, improper removal/installation, or debris causing binding.
- Wiring faults such as chafed cables or poor contacts between pedal connector and harness.
- Symptoms typically include throttle hesitation, jerky acceleration, illumination of the engine or throttle warning light, or the vehicle entering limp mode.
Why Buy This Part
Direct-fit Bosch component with OE cross-references, suitable for mechanics seeking a reliable replacement for Peugeot 307 and related models. Clear part-number references in the listing make it easy to find the correct unit quickly in search engines and parts catalogs.
Notes
This listing contains commonly used OEM and supplier numbers to help identify compatibility. Replacement of electronic throttle components should be performed with care and, where required, followed by the manufacturer’s calibration procedure to restore full functionality.
