Description
Accelerator pedal for Peugeot 206
Product Overview
Electronic accelerator pedal assembly for Peugeot 206, manufactured by Bosch and referenced under OEM numbers commonly used on Stellantis vehicles. This pedal integrates a potentiometric throttle position sensor to transmit precise accelerator position data to the engine management system. Replacement of the pedal restores accurate throttle response, improves drivability and eliminates fault indications related to pedal position.
Technical Information
- Manufacturer: Bosch (OEM Supplier)
- Model: Peugeot 206
- Product Codes: 9645852280, 0280752237, 1601Q2
- Additional Numbers: 280752237
Compatibility And Application
Designed as a direct-fit replacement for Peugeot 206 models that use the Bosch electronic accelerator pedal assembly with the listed part numbers. Always match part numbers on the replacement unit with the original to ensure correct fitment and connector compatibility.
Replacement Procedure (General Guide)
1. Park vehicle on a level surface, engage parking brake. Before starting work, disconnect the negative terminal of the battery to avoid electrical damage.
2. Remove lower dashboard trim or footwell cover to access the pedal assembly.
3. Unplug the electrical connector from the pedal sensor—inspect connector and wiring for damage or corrosion.
4. Unscrew the mounting bolts securing the pedal assembly to the bulkhead or pedal bracket and remove the old pedal.
5. Fit the new pedal assembly, tighten mounting bolts to the manufacturer’s torque specification if available, reconnect the electrical connector and reassemble trim.
6. Reconnect the battery. Perform any required throttle/ECU relearn or adaptation procedure as specified by the vehicle manufacturer or diagnostic tool.
Installation Recommendations
– Always Disconnect The Battery Before Removal Or Installation.
– Inspect Wiring Harness And Connectors For Damage; Repair Or Replace If Necessary.
– Avoid Forcing The Pedal Assembly During Installation; Ensure Correct Alignment Of Mounting Points.
– After Installation, Carry Out Throttle Sensor Calibration Or Adaptation Using A Suitable Diagnostic Tool If The Vehicle Requires It.
Why This Part Fails Most Often
Electronic accelerator pedals commonly fail due to wear of the internal potentiometric sensor, contamination or moisture ingress, connector corrosion, or mechanical damage from impact. Symptoms include irregular throttle response, hesitation, reduced engine power (limp mode), or dashboard fault lights indicating pedal/sensor faults. Failures are more likely on higher-mileage cars or where footwell moisture and dirt can reach the sensor and connectors.
Benefits Of Replacing The Pedal
Replacing a faulty accelerator pedal restores precise throttle control and pedal feel, eliminates intermittent drivability issues and related fault codes, and prevents unexpected power limitations imposed by the engine management system. Using a part that matches OEM reference numbers helps ensure correct electrical and mechanical compatibility.
