Description
Bosch Accelerator Pedal for Citroën Berlingo and Peugeot Partner.
Product Overview
High-quality Bosch accelerator pedal assembly designed as a direct-fit replacement for selected Citroën Berlingo and Peugeot Partner models. This electronic throttle position sensor/pedal provides precise driver input transmission to the engine management system, helping restore smooth throttle response and eliminate pedal-related fault codes.
Key Features
- OE-Level Manufacture: Bosch engineering and build quality for reliable operation and long service life.
- Direct Fitment: Designed to match original mounting points and connector interfaces for easy replacement.
- Multiple Reference Numbers: Compatible with common part references used on Stellantis vehicles.
- Suitable For Professionals And Skilled DIYers: Clear replacement procedure and typical checks included below.
Technical Information
- Manufacturer: Bosch
- Model: Citroën Berlingo; Peugeot Partner
- Product Codes: 0280755035 / 1601T8 / 9655467180
- Additional Numbers: 0280755035, 1601T8, 9655467180
Fitment And Compatibility
This pedal assembly is listed for Citroën Berlingo and Peugeot Partner applications that use the referenced part numbers. Always verify the part number on the defective unit before ordering to ensure correct match. The unit connects to the vehicle wiring harness via the original connector and mounts in the existing pedal bracket.
Installation Recommendations
- Disconnect the battery before starting work to avoid short circuits and protect vehicle electronics.
- Remove lower dash trim or footwell covers to access the pedal assembly. Keep fasteners organized for reassembly.
- Unplug the electrical connector carefully—avoid pulling on the wiring. Inspect connector pins for corrosion or damage.
- Remove mounting bolts securing the pedal assembly (typically 2–3 fasteners) and extract the unit from the bracket.
- Install the new pedal assembly, tighten mounting bolts to manufacturer specification, reconnect the electrical plug and reassemble trim.
- After installation, clear any stored fault codes and perform throttle/sensor adaptation if required by the vehicle. Some vehicles may need a diagnostic tool for final calibration.
Why This Part Fails
Electronic accelerator pedals are not wear items with a fixed replacement interval. Common causes of failure include internal sensor wear or drift (potentiometer or Hall effect sensor), contamination or moisture ingress into the sensor housing, damaged connector pins or wiring harness, and mechanical damage to the pedal mechanism. When the pedal sensor degrades, symptoms typically include throttle hesitation, reduced engine response, warning lights, or the vehicle entering limp mode.
Practical Tips For Diagnosis
- Inspect wiring and connector first—many faults are caused by poor connections or damaged cables rather than the pedal itself.
- Check for visible signs of water ingress or corrosion on the sensor and connector.
- Use an appropriate diagnostic tool to read fault codes and live sensor values before replacing the unit to confirm the pedal as the root cause.
- Keep the old unit until the new part is confirmed working, in case of warranty or reference needs.
Recommended For
Automechanics and experienced DIYers seeking a direct replacement Bosch accelerator pedal for Citroën Berlingo and Peugeot Partner vehicles that reference the part numbers listed above. Ideal when throttle-related fault codes or poor pedal response indicate a faulty pedal position sensor.
