Description
Front passenger door lock for Stellantis group vehicles: Citroën, Peugeot, Opel, Fiat and Toyota.
This Front Passenger Door Lock (Reference: 9816343380) is a direct-fit replacement designed for vehicle workshops and experienced DIYers working on Citroën and Peugeot family models. Built to restore secure door locking and reliable central locking operation, the unit suits mechanics who need a robust spare part that integrates with factory linkages and electrical connectors. Keywords: Front Door Lock, Passenger Door Lock, 9816343380, Citroën Berlingo, Peugeot Partner, Peugeot Rifter, Opel Combo.
Function
The Door Lock Assembly Secures The Front Passenger Door, Interfaces With The Central Locking System And Translates Actuator Movement To Mechanical Latches. It Contains The Latching Mechanism, Electrical Connector For The Central Lock Actuator, And Linkage Attachments For Internal Handles And Striker. Proper Operation Ensures Door Remains Closed At Speed And Opens Smoothly From Inside And Outside.
Technical Information
- Manufacturer: Stellantis
- Model: Citroën Berlingo III (K9), Peugeot Partner III, Peugeot Rifter, Opel Combo E (K9)
- Product Codes: 9816343380
- Additional Numbers: No Further OEM Numbers Available In Provided Data
Replacement Procedure
Replacement Requires Basic Door Trim Removal And Electrical Disconnection. Typical Steps:
- Remove Interior Door Trim Panel And Any Vapor Barriers Carefully To Access The Locking Unit.
- Disconnect The Electrical Connector For The Central Lock Actuator And Detach Linkage Rods From Handles And Striker.
- Unscrew The Lock Assembly Fixings From The Door Shell And Withdraw The Unit.
- Install The New Lock In Reverse Order, Reconnect Linkages And Electrical Connector, Then Check Mechanical Travel And Electrical Lock/Unlock Functions.
- Test Door Operation Several Times With The Vehicle Stationary And Confirm Central Locking Works From All Positions.
Installation Recommendations
- Use Appropriate Trim Tools To Avoid Damaging Clips And Door Panel.
- Inspect Striker And Linkage For Wear; Replace Or Adjust If Excessive Play Is Found.
- Lubricate Moving Parts With Suitable Grease To Prevent Premature Wear And Corrosion.
- Ensure Electrical Connector Pins Are Clean And Free Of Corrosion Before Reconnection.
- After Installation, Verify Central Locking Operation And Manual Release From Inside And Outside.
Why This Part Most Commonly Fails
Failures Are Usually Caused By Mechanical Wear Of Plastic Gears Or Linkage Points, Water Ingress Leading To Corrosion, Or A Worn Actuator Motor. Repeated Stress From Frequent Lock/Unlock Cycles Or Forceful Handle Use Accelerates Wear. Improper Alignment Between The Lock And Door Striker Can Also Cause Premature Failure And Difficulty In Latching.
Practical Notes For Mechanics And DIYers
Keep The Reference Number 9816343380 Handy When Searching Catalogs Or Ordering Parts. Replace The Lock As A Complete Assembly To Avoid Future Issues Caused By Reused, Worn Components. If The Door Exhibits Intermittent Central Locking Failures, Inspect The Wiring And Grounds Before Replacing The Entire Lock To Diagnose Electrical Causes.
