Description
BEHR Heater Servo Motor For PEUGEOT 3008 And 5008 First Generation. The Gear Section Can Be Removed And The Motor Alone Can Be Used.
Overview
High-quality BEHR heater servo motor designed for climate control actuators in first-generation Peugeot 3008 and 5008 vehicles. This compact HVAC actuator drives blend/recirculation/door flaps to regulate cabin temperature and airflow precisely. The unit is a direct-fit replacement for worn or failed servomotors and is often sought by mechanics and DIY technicians under part numbers Z5509001, 2706149C or 647997.
Technical Information
- Manufacturer: BEHR
- Model: Peugeot 3008 I; Peugeot 5008 I (First Generation)
- Product Codes: Z5509001
- Additional Numbers: 2706149C, 647997
Function And Common Symptoms
This servo motor operates HVAC flap mechanisms to control temperature blend and air distribution. When the actuator fails, typical symptoms include erratic temperature regulation, stuck or noisy vents, incorrect airflow direction, or climate control fault codes. In many cases failure manifests as grinding noises from the dashboard or the vent doors not moving to commanded positions.
Why The Part Usually Fails
- Plastic Gear Wear Or Breakage: Repeated movement and age cause plastic gears to strip or fracture.
- Electrical Wear (Brushes/Commutator) Or Bearing Failure: Internal motor wear leads to loss of torque or intermittent operation.
- Contamination And Corrosion: Moisture ingress, dust or grease contamination can seize the mechanism or damage electrical contacts.
- Overheating Or Mechanical Overload: Obstructed flaps or excessive resistance shortens motor life.
Replacement And Installation
Before Starting, Disconnect The Battery To Avoid Short Circuits. Access Typically Requires Removal Of The Glove Box Or Lower Dashboard Panels Depending On Model. Remove The Old Actuator By Unplugging The Electrical Connector And Unscrewing The Fasteners. Observe Actuator Orientation And Flap Linkage For Correct Reassembly.
Note: The Gear Section Can Be Removed And The Motor Used Alone Where Applicable. If You Intend To Remove The Gear, Inspect For Wear, Replace Any Damaged Plastic Gears, And Ensure Proper Meshing And Lubrication To Avoid Premature Failure.
Installation Recommendations
- Perform A Functional Test Before Final Assembly: Connect The Harness And Cycle The HVAC Controls To Verify Movement And Silence.
- Check Wiring And Connector Pins For Corrosion Or Damage; Repair As Necessary.
- Use Correct Fasteners And Torque Settings To Prevent Vibration Loosening.
- After Installation, Allow The HVAC Module To Recalibrate Through The Vehicle Controls If Required.
- Replace Both Actuator And Any Damaged Gears If Gear Damage Is Present To Ensure Long-Term Reliability.
Why Choose This Unit
BEHR Is A Recognized Supplier In Automotive Thermal Management. This servo motor Offers A Cost-Effective Solution For Restoring Proper Climate Control Function In Affected Peugeot 3008 And 5008 First-Generation Vehicles. Clear Identification By Part Numbers Z5509001, 2706149C And 647997 Helps Locate The Correct Fit Quickly.
Additional Notes
Designed For Use In Stellantis HVAC Systems On The Specified Models. Ideal For Professional Workshops And Experienced DIYers Performing Climate Control Repairs.
Recommendation For Service
When Replacing The Actuator, Inspect The Entire HVAC Mechanism Including Linkages, Gears And Seals. Address Root Causes Such As Water Leaks Or Blockages To Prevent Repeat Failures.
