Description
Climate blower fan for Stellantis group vehicles Citroën, Peugeot, Opel, Fiat, Toyota
This heater / HVAC blower motor is a direct-fit solution commonly referenced under part numbers 9821292180 and 9849717380. Designed for use in a range of Stellantis small vans and MPVs, the unit restores proper airflow through the heating and ventilation system, ensuring cabin comfort and efficient demisting. Ideal for professional workshops and competent DIYers, the fan is often located and ordered by its product code, so listing the correct reference numbers increases findability and speeds up repairs.
Technical information
- Manufacturer: Stellantis
- Model: Citroën Berlingo III (K9), Peugeot Partner III, Peugeot Rifter, Opel Combo E / Combo K9, (also referenced in listings for other Stellantis platforms)
- Product Codes: 9821292180, 9849717380
- Other Numbers: Common aftermarket and cross-reference lists may use the above codes; search by these references for fast lookup.
Function
The blower motor circulates air through the vehicle’s heating, ventilation and air-conditioning (HVAC) system. It supplies passenger-cabin airflow for heating, cooling and demisting. Proper blower operation is essential for cabin comfort and clear visibility.
How To Replace
- Safety First: Disconnect the negative battery terminal before beginning work to avoid electrical short circuits.
- Access: On most listed models the blower is accessed from below the glovebox or behind lower dashboard panels. Remove the glovebox or the necessary trim to reach the blower housing.
- Disconnect: Unplug the electrical connector and remove the retaining screws or clips that secure the blower assembly.
- Remove And Replace: Withdraw the old blower unit, install the replacement in reverse order, ensure a secure mechanical fit and reconnect the electrical connector.
- Check System: Reconnect the battery, verify blower operation at all speed settings and confirm there are no unusual noises or electrical faults.
Installation Recommendations
- Perform installation in a clean workspace to avoid introducing debris into the HVAC system.
- Inspect the blower intake and cabin filter during replacement; clogged filters increase motor load and shorten life.
- Verify fuses, wiring and the blower speed control module/resistor if the new motor does not operate correctly at all speeds.
- Use the correct fasteners and ensure gaskets or seals are correctly positioned to prevent air leaks and noise.
Why The Part Most Often Fails
- Worn Brushes Or Bearings: Mechanical wear in the motor causes noise, reduced speed or seizure over time.
- Debris And Contamination: Leaves, dust and moisture entering the intake can jam the fan or corrode components.
- Overheating And Electrical Stress: Blocked airflow or electrical faults in the blower resistor/control unit increase load and accelerate failure.
- Water Ingress: Leaks in the cowl area may allow water to reach the motor and cause short circuits or corrosion.
- Age And Usage: High-mileage vehicles with frequent HVAC use naturally see shortened blower life.
Searching by part number (9821292180, 9849717380) is the fastest way to identify this blower for Citroën Berlingo, Peugeot Partner/Rifter and Opel Combo applications. For professional repairs, confirm fitment against the vehicle’s parts list before ordering and follow manufacturer procedures during replacement to ensure reliable operation and long service life.
