Description
Right rear light for PEUGEOT 307 SW from 2005. Without bulb sockets; bulbs can be purchased separately. Passenger side.
This used right-hand rear tail lamp is a direct-fit replacement for Peugeot 307 SW models and is commonly sought by mechanics and DIY enthusiasts by its OEM references. The unit houses the rear position (tail), brake and indicator light circuits; bulbs and bulb holders are not included. Supplied as a complete lamp assembly with the original connector and mounting points, it is ideal for repairing damaged rear lighting after minor collisions, cracked lenses or electrical faults.
Compatibility And Application
Fits Peugeot 307 SW (estate) applications. Frequently referenced by part numbers listed below — buyers often search by these codes to confirm fitment. Suitable for models in the 307 I and II range where the same rear lamp assembly is used.
How To Replace
- Open the tailgate and remove the inner trim panel to access the lamp fasteners.
- Unscrew the mounting bolts (usually 2–3) and carefully pull the lamp body outward.
- Disconnect the wiring connector by pressing the locking tab and sliding the plug free.
- Remove the old lamp, fit the replacement assembly, reconnect the wiring and test all functions before closing the trim.
- Refit the trim and tighten fasteners to the manufacturer’s recommendations.
Installation Recommendations
- Work on a cool, dry car and avoid forcing plastic tabs — breakage of clips is the most common cause of poor reassembly.
- Check and, if necessary, replace the rubber gasket or seal around the lamp to prevent water ingress.
- Use dielectric grease on electrical contacts to reduce corrosion and improve long-term reliability.
- Replace bulbs and bulb holders if they show signs of wear, corrosion or melting — this lamp is supplied without sockets/bulbs.
- After installation, verify all light functions (tail/stop/indicator) and ensure lens alignment for correct visibility.
Why This Part Fails Most Often
Rear lamp assemblies commonly fail due to water ingress through deteriorated seals or cracked lenses, leading to corrosion of bulb contacts or short circuits. Impact damage from minor collisions frequently breaks mounting tabs or the outer lens. Heat stress from worn or incorrect bulbs can deform sockets. Corroded wiring connectors from moisture exposure also cause intermittent or complete failure.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 307 SW
- Product Codes: 9655768580, 9655768480
- Other Numbers: 6351X3, 6351X2, 6351.X3, 6351.X2
Keywords to help find this part: Peugeot 307 SW right rear light, tail lamp 9655768580, 6351X3, rear lamp passenger side, used Peugeot tail light.
