Description
Left Rear Light For Peugeot 307 SW From 2005. Without Bulb Sockets; Bulb Holders Can Be Purchased Separately. Side: Driver’s Side.
This left rear lamp is a direct replacement for Peugeot 307 SW estate models from 2005 onwards. Designed for professional workshops and DIY mechanics, the unit restores rear lighting functions and original appearance after damage or wear. Commonly searched under product codes 6350X3 and 6350X2, this lamp is a straightforward fit for the driver side (left) tail panel and is ideal when the original housing is cracked, faded, or water-damaged.
Technical Information
- Manufacturer: Stellantis (Peugeot)
- Model: Peugeot 307 SW (Estate) – From 2005
- Product Codes: 6350X3, 6350X2
- Additional Numbers: None Specified
Functions
The rear lamp provides the vehicle’s rear lighting functions for the left side, including tail light and brake light circuits and the turn signal/reversing light positions depending on the vehicle wiring and bulb configuration. Because this unit is supplied without bulb sockets, fitment of the correct sockets and bulbs is required to restore full functionality.
Compatibility And Fitment Notes
Intended For Peugeot 307 SW Estate Models From 2005. Confirm Fitment By Matching Product Codes 6350X3 Or 6350X2 On Existing Unit. This lamp is Built To Replace The Left (Driver’s) Rear Combination Lamp And Matches Factory Mounting Points.
Replacement Procedure
- Open Tailgate And Remove Interior Trim Panel To Access Rear Lamp Fasteners.
- Unscrew Fasteners (Typical Tools: Phillips/Flat Screwdriver, Torx Or 10 Mm Socket Depending On Model) And Carefully Pull Lamp Assembly Outwards.
- Disconnect Electrical Connector(s) And Remove Old Lamp.
- If Required, Install New Bulb Holders And Bulbs Into The New Lamp Housing.
- Reconnect Wiring, Fit Lamp Into Body Aperture And Tighten Fasteners Securely.
- Test All Functions (Tail, Brake, Indicator, Reverse/Fog If Applicable) Before Reinstalling Interior Trim.
Installation Recommendations
- Use Appropriate Hand Tools And A Trim Tool To Avoid Damaging Interior Panels.
- Replace Any Damaged Seals Or Gaskets To Prevent Water Ingress; Ensure Mounting Surface Is Clean.
- Apply Dielectric Grease To Electrical Connectors To Reduce Corrosion And Improve Contact.
- Fit Bulb Holders And Bulbs Specified By Peugeot; Verify Bulb Types For Your Vehicle Variant.
- Check Alignment And Secure Fasteners To Manufacturer’s Tightening Practice To Prevent Vibration Loosening.
Why This Part Most Commonly Fails
Rear Lamps Typically Fail Due To Impact Damage In Minor Collisions, Cracked Or Faded Lenses From UV Exposure, Water Ingress Leading To Corrosion Of Sockets And Connectors, Or Internal Condensation Causing Electrical Faults. Incorrect Bulb Wattage Or Damaged Seals Can Also Accelerate Wear.
This replacement lamp Offers A Cost-Effective Way To Restore Safety And Legal Rear Lighting Performance While Maintaining The Original Look Of The Peugeot 307 SW.
