Description
Right rear lamp for Peugeot 307 SW up to 2005. Without bulb sockets; these can be purchased from us.
This right rear lamp is a direct-fit replacement designed for Peugeot 307 SW (estate) models produced up to 2005. The complete light assembly houses the tail, brake, indicator and reversing lamp positions depending on the vehicle equipment. It is an ideal choice for mechanics and DIY owners who need a reliable passenger-side rear light to restore visibility and legal road lighting after damage or wear. Supplied without bulb sockets—bulb holders and bulbs are available separately.
Key Benefits
- Direct replacement for passenger-side rear lamp on Peugeot 307 SW (pre-2005).
- Restores full rear lighting functions: tail, stop, indicator and reverse (depending on vehicle configuration).
- High compatibility with original mounting points for an easy fit and secure attachment.
- Improves road safety and restores vehicle appearance after impact or aging damage.
Installation / Replacement Guide
Replacement is straightforward for a trained mechanic or an experienced DIYer. Typical steps:
- Open the tailgate and remove the interior trim or access panel to reach the lamp fixing screws.
- Unscrew the retaining bolts or nuts that secure the lamp assembly to the body.
- Carefully pull the lamp assembly outwards and disconnect the wiring connector(s).
- Fit the new lamp into the body, reconnect the wiring harness and secure with the original fasteners.
- Install bulb holders and bulbs if required, check all functions (tail, stop, indicator, reverse) and refit the trim.
Recommended Tools: Torx or Phillips screwdriver depending on vehicle trim, 8–10 mm socket, panel trim tool, and a multimeter for quick function checks.
Mounting Recommendations
- Inspect the wiring connector and body grommet for corrosion or damage; replace if necessary to prevent poor contact or water ingress.
- Use the original fasteners where possible and tighten to the vehicle manufacturer’s specifications to avoid deformation.
- Seal around the lamp edge with appropriate sealant if previous water ingress was present.
- Test all light functions after installation and adjust alignment if required by local regulations.
Why This Part Most Commonly Fails
- Impact damage from collisions or minor knocks that crack the lens or the housing.
- Water ingress leading to corrosion of contacts, bulb holder failure and short circuits.
- UV exposure and age-related brittleness causing lens clouding, cracks or loss of sealing.
- Poor electrical contact at the connector or socket due to corrosion or worn contacts.
Technical Information
- Manufacturer: Peugeot / Citroën (Stellantis)
- Model: Peugeot 307 SW (Estate), up to 2005
- Product Codes: 6351Q6
- Other Numbers: NFP
Additional Notes
When replacing the lamp, consider renewing bulb holders and bulbs if they show signs of wear or corrosion. Correct installation restores full functionality and helps avoid electrical faults. This part is commonly requested under code 6351Q6—using the product code in searches will help you find the correct replacement faster.
