Description
Original rear fog light for the passenger side for Peugeot 3008 first generation. With bulb.
Product Overview
Genuine rear fog lamp designed as a direct replacement for the passenger side of the Peugeot 3008 (first generation). Supplied with a bulb, this unit restores rear visibility in poor weather and ensures compliance with road safety requirements. Ideal for professional workshops and experienced DIYers who expect an exact fit and reliable operation.
Key Benefits
- Direct OE fitment for easy installation and precise alignment.
- Supplied With Bulb, reducing installation time and the need to source a lamp separately.
- Restores Visibility And Safety In Fog, Heavy Rain And Low-Visibility Conditions.
- Durable Housing Designed To Match Original Mounting Points And Connectors.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 3008 I (First Generation)
- Product Codes: 9685463580, 6351HG
- Additional Numbers: 6351HG | 9685463580
Compatibility & Fitment
Fits Peugeot 3008 First Generation models. Always verify the part numbers listed above against the part being replaced to ensure correct fitment. This unit is intended as a passenger-side rear fog light and matches the original mounting and electrical connector used on the vehicle.
Installation Recommendations
- Access The Unit From The Trunk/Boot Or By Removing The Rear Bumper Depending On Vehicle Trim.
- Remove Any Interior Trim Panels To Reach The Fog Lamp Housing And Fasteners.
- Unscrew Mounting Bolts, Carefully Disconnect The Electrical Connector And Remove The Old Unit.
- Replace The Bulb/Holder If Required Or Transfer The Bulb From The Old Unit If Compatible.
- Install The New Lamp, Reconnect The Electrical Connector And Secure All Fasteners To Manufacturer Torque Where Available.
- Check Lamp Alignment And Operation After Installation.
- Recommended For Professional Installation Or By Experienced DIYers With Basic Automotive Tools.
Why The Part Fails
Rear fog lights commonly fail due to bulb burnout, water ingress leading to corrosion or short circuits, cracked lens or housing from impacts, and damaged connectors or wiring from moisture and road debris. Regular inspection of seals and electrical connections helps prevent premature failure. The bulb supplied with this unit addresses one of the most frequent failure causes immediately upon replacement.
Notes For Mechanics And DIYers
- Keep Replacement Bulbs And Seals Dry And Free From Contamination During Installation.
- Ensure Connectors Are Clean And Secure; Corroded Contacts Should Be Repaired Or Replaced.
- After Installation, Test The Lamp In Real Conditions When Possible To Confirm Correct Operation.
