Description
Left rear lamp for PEUGEOT 3008 cars of the first generation facelift
Without bulb socket – can be bought extra here
Side behind the driver
Part description
This used Peugeot 3008 left rear light is intended for the cars listed in the documents and is a practical choice for repairing damaged rear lighting. Thanks to the product number 9805510580, the part is easily traceable and easy to compare with the original piece.
The light is supplied without a bulb socket, which needs to be solved separately. It is suitable for mechanics and do-it-yourselfers who are looking for an original used Peugeot car part with an emphasis on a reasonable price and preserving the original appearance of the car.
Technical information
Product codes
- Product codes: 9805510580
- Models from labels/backgrounds: Peugeot 3008 I
Installation recommendations
Generally/typically for replacing a tail light, the exact procedure may vary depending on the specific design of the car and the approach to fixing the part.
1) Before assembly
- Check that the left side and the execution of the part match according to the original light.
- Compare product number 9805510580, light shape, mounting, connector and seating surfaces.
- Check the condition of the cover, attachment points and sealing surfaces for leaks or play after installation.
- Since the part is without a bulb socket, prepare the original socket or a suitable replacement if you already have one available.
2) Necessary tools and materials
- Basic set of common hand tools
- Screwdriver or plastic pry bar to remove paneling if needed
- Clean cloth
- Preparation for cleaning contact surfaces
- Work gloves
3) Step-by-step assembly procedure
- Turn off the ignition and secure the car against movement.
- Open access to the rear of the light, typically from the luggage compartment or by opening the relevant cover.
- Carefully disconnect the electrical connector from the original light.
- Undo the fasteners of the old light and carefully remove the part so as not to damage the paintwork or plastic parts around it.
- Inspect the body mating surface and remove any dirt, dust or old gasket residue if present.
- Compare the original and new part side by side, especially the mounting, connector and cover shape.
- If the original bulb socket is used, relocate it according to the design of the part and check its condition.
- Place the new light in place so that it fits properly without tension and does not interfere with the wiring harness.
- Install and evenly tighten the fasteners so that the light fits tightly, but without unnecessary overloading of the plastic parts.
- Connect the electrical connector.
- Check the alignment of the light with the surrounding bodywork.
- Return any removed covers or trim.
-
4) Post-assembly checks and test drive/function verification
- Verify the function of the backlight in all modes that the light uses.
- Check that the light is firmly in place and does not move anywhere.
- After a short ride, recheck the seat of the part and possibly also signs of moisture penetration.
- If the paneling around the light has been removed, check that it is properly attached and that the wiring is not pinched.
5) The most common assembly mistakes + how to avoid them
- Swapping part side – always compare the orientation of the light with the old part before mounting.
- Using a damaged or unsuitable socket – check its condition and correct seating.
- Insufficient cleaning of the bearing surface – can lead to incorrect alignment or leakage.
- Too much tightening of the fastening – can damage plastic parts or mounts.
- Poorly connected connector – always verify correct connection and function of light before completing assembly.
Reasons why the part is damaged
- Damage from parking or minor impact
- Cracking of the cover due to an accident or careless handling
- Intrusion of moisture into the light after damage to the seal or attachment
- Wearing of attachment points during repeated disassembly
- Damage to the electrical part due to contact corrosion or moisture
