Description
Socket with bulbs and a section of wiring for the left rear lamp of the PEUGEOT 206 Combi. The connector and socket are not heated; they are fully functional.
This lamp holder with attached wiring harness is a practical replacement part for the left rear tail lamp of the Peugeot 206 Combi (estate). Supplied with bulbs and a portion of cable, the assembly restores reliable electrical contact and correct bulb positioning for the tail/brake/indicator circuits (vehicle variant dependent). The unit is suitable for professional workshops and experienced DIYers who want a direct-fit repair solution that reduces diagnostic time and ensures correct illumination of the rear lamp cluster. Typical search terms: Peugeot 206 left rear lamp socket, tail light holder 6350R4, Peugeot 206 Combi lamp wiring.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 206 Combi
- Product Codes: 6350R4
- Additional Numbers: Not provided
How To Replace
- Disconnect the negative battery terminal before any work to avoid short circuits.
- Open the rear boot and remove the interior trim to access the lamp assembly.
- Unscrew or unclip the lamp housing from the body and gently pull the lamp out to reach the socket.
- Unplug the original connector, remove the old socket and install the new socket with the wiring harness supplied.
- Fit bulbs into the new socket, plug in the connector and test all lamp functions (tail, brake, indicator and reverse if applicable).
- Reassemble the lamp housing and interior trim, then reconnect the battery and perform a final function check.
Installation Recommendations
- Always disconnect the battery before starting work and follow manufacturer procedures to avoid damage to vehicle electronics.
- Check and use the correct bulb types and ratings for your vehicle variant; incorrect bulbs can cause overheating and premature failure.
- Apply a small amount of dielectric grease to connector pins to improve corrosion resistance and electrical contact.
- Route and secure the wiring away from sharp edges, pinch points and hot surfaces to prevent chafing and insulation damage.
- After installation, verify all light functions from both a static and dynamic test (indicator blink, brake application, reversing light where applicable).
Why This Part Fails Most Often
- Corrosion of contacts caused by moisture ingress is the most common cause of poor connection and intermittent lighting.
- Overheating from incorrect or overloaded bulbs can deform the socket and melt insulation over time.
- Mechanical stress, vibration and repeated lamp replacement can loosen contacts or break wires in the harness.
- Water leaks into the lamp housing or poor sealing accelerate connector and socket deterioration.
Inspection of the socket and connector is recommended whenever rear bulbs are replaced or when symptoms such as flickering, dimming, intermittent operation or complete failure occur. The supplied assembly offers a straightforward way to restore reliable rear lamp operation on the Peugeot 206 Combi.
