Description
Inner door handle for right front and rear doors for CITROËN and PEUGEOT vehicles. Color HVV – Lion Gray.
This inner right-hand door handle is a direct-fit replacement commonly used on a range of Citroën and Peugeot models. Designed for mechanics and DIY enthusiasts, the unit restores reliable interior operation when the original handle becomes loose, cracked or fails to engage the latch. The part is frequently searched by its reference numbers (9660525380, 9685950277, 9800099680, 9144G4, 9144F6), so including these codes in your search will help you find the correct item quickly.
Compatibility
- Citroën C-Elysée
- Citroën C4
- Citroën C4 II
- Citroën C4 Picasso
- Citroën C5 X7
- Peugeot 301
- Peugeot 308
- Peugeot 407
- Peugeot 508 (check body and year compatibility)
Technical Information
- Manufacturer: Stellantis / Citroën / Peugeot
- Model: Inner Right Door Handle (Front And Rear)
- Product Codes: 9660525380, 9685950277, 9800099680
- Other Numbers: 9144G4, 9144F6
- Color: HVV – Lion Gray
- Position: Right Side, Suitable For Both Front And Rear Doors (Where Applicable)
Installation Recommendations
Fitment is straightforward for a trained technician or experienced DIYer. Typical replacement steps:
- Remove the inner door trim panel by releasing clips and disconnecting any electrical connectors for switches or courtesy lights.
- Locate and remove the fixing screws or rivets securing the old handle (retain any reusable fasteners if intact).
- Disconnect the mechanical linkage or plastic rods from the handle. Note the orientation and clip positions for reassembly.
- Install the new handle, connect linkage and check smooth movement before re-securing the screws.
- Reassemble the door trim, making sure all clips and seals are properly seated to avoid rattles or water ingress.
Use basic hand tools. Avoid excessive force on plastic clips; replace broken retainers with OEM-style clips to ensure long-term fit. After installation, test door opening/closing and child lock functions where applicable.
Common Failure Causes
- Plastic Fatigue: Internal plastic levers and clips weaken over time and can crack or snap, especially with frequent or rough operation.
- Wear Of Pivot Points: Repeated use causes play in pivots, resulting in a loose or slipping handle that may not fully engage the latch.
- Impact Or Abuse: Excessive force on the handle (e.g., pulling while door is stuck) can fracture the assembly.
- Corrosion Or Debris: Moisture and dirt inside the door can impair linkage movement and accelerate wear.
Replacing a worn or broken inner handle restores proper door operation and prevents further damage to linkage and latch components. Search by the product codes listed above to ensure quick identification of the correct part for the vehicle.
