Description
Right wing mirror for CITROEN BERLINGO II and PEUGEOT PARTNER II
Passenger side
Part description
This used right mirror is intended for Citroën Berlingo II and Peugeot Partner II cars. It is a part on the passenger side, which is important for a safe view from the car, comfortable maneuvering and normal operation.
The advantage is identification by product numbers, which makes it easier to find the right part when repairing or replacing a damaged original mirror. A used original car part is a practical choice for auto mechanics and do-it-yourselfers who want to preserve the original design of the car and at the same time reasonable repair costs.
Technical information
- Manufacturer: Stellantis Citroën Peugeot
- Model: Citroën Berlingo II, Peugeot Partner II
- Other numbers: 96193823XT, 8153HR
Product codes
- Product codes: 96193823XT, 8153HR
- Model names: Citroën Berlingo, Peugeot Partner
Installation recommendations
Generally/typically for exterior rearview mirror replacement, the exact procedure may vary depending on the specific car design and equipment. Always compare the new and original part before assembly.
1) Before assembly
- Check if it is the right passenger side mirror.
- Compare the shape of the mirror, the mount, the cover, the connectors and the number of connection points with the old part.
- Check the condition of the used part – especially the strength of the attachment, the undamaged cover, the glass and any electrical parts, if they are included.
- Check for cracked mounting points or damaged wiring.
2) Necessary tools and materials
- Set of common hand tools
- Screwdrivers and suitable attachments
- Plastic pry bar for panel removal
- Detergent and clean cloth
- Possibly, work gloves and a flashlight
3) Step-by-step assembly procedure
- Park the vehicle in a safe place and turn off the ignition.
- Open the relevant door and access the inner cover or part of the trim near the mirror attachment.
- Carefully remove the inner cover element or trim so as not to damage the fasteners.
- If the mirror is equipped with an electrical connection, carefully disconnect the connector.
- Loosen the fasteners of the old mirror and at the same time hold it from the outside so that it does not fall.
- Remove the original mirror and compare its design with the assembled piece.
- Clean the landing surface and check that there are no dirt or damaged parts left in the attachment point.
- Place the replacement mirror in the correct position and align its attachment.
- Install and tighten fasteners evenly without unnecessary switching.
- If included in the electrical connection, reconnect the connector and check for proper seating.
- Reinstall the cover plastic or door trim.
- Adjust the position of the mirror for the normal view of the driver.
-
4) Post-assembly checks and function verification
- Check that the mirror is firmly held and shows no play.
- Check that it fits correctly on the bodywork and that there are no gaps in the attachment.
- If the part has electrical functions, verify their operation after connection.
- During a short test drive, check that the mirror does not vibrate more than the original part and provides a sufficient view.
5) The most common assembly mistakes + how to avoid them
- Swapping left and right parts – always check the passenger side before fitting.
- Not comparing the fit with the old piece – compare the shape, holes and connectors before fitting.
- Damage to plastic covers during disassembly – use a plastic pry bar and work carefully.
- Insufficient connector seating – after plugging in, check that the connector is firmly in place.
- Contact with an obstacle when parking or driving in a narrow space
- Impact from another vehicle, cyclist or pedestrian
- Mirror bending or breaking due to mechanical stress
- Cracking of glass or cover after a minor collision
- Wear of attachment and play caused by long-term use
- Damage to wiring or internal parts due to age and humidity
