Description
BEHR heater servo motor for PEUGEOT 3008 and 5008 first generation. Only the motor; the gear section is missing, it can be fitted from your original unit.
This BEHR heater servo motor is designed to control HVAC flaps in first‑generation Peugeot 3008 and 5008 models, regulating airflow and temperature blend inside the passenger compartment. The unit itself contains the electric motor and position feedback components; the plastic gear carrier is not included and must be transferred from the original actuator or replaced separately. Ideal for professional garages and DIY mechanics looking for a direct functional replacement of the drive motor assembly (reference numbers included).
Features
- Direct fit motor element for BEHR HVAC actuators used in Peugeot 3008 I and 5008 I.
- Controls blend/temperature flap movement and position feedback within the heater box.
- Supplied as motor only — gear section is missing and must be fitted from the original unit.
- Commonly referenced under part codes for quick lookup (see Technical information).
Technical information
- Manufacturer: BEHR
- Model: Peugeot 3008 I, Peugeot 5008 I (First Generation)
- Product Codes: EAD516, P1975001, 647995
- Additional Numbers: Stellantis / Citroën Peugeot references (see Product Codes)
Installation Recommendations
Basic replacement steps (typical procedure for experienced mechanics):
- Always disconnect the negative battery terminal before starting work to avoid electrical damage.
- Access the HVAC unit — on these models the actuator is usually located behind the glovebox or lower dash panel; remove trim panels as required.
- Unplug the electrical connector and remove the retaining screws securing the actuator to the heater box.
- Remove the actuator motor assembly. Transfer the plastic gear carrier from the original actuator to this motor if you do not have a replacement gear assembly.
- Reinstall the actuator, secure screws, reconnect the electrical connector and reassemble trim panels.
- Reconnect the battery and perform an operational check: cycle the climate controls through modes and temperatures to verify flap movement and correct positioning.
Use basic hand tools and a torque driver for small screws. If flap calibration is required, cycle the system through its automatic self‑test by following the vehicle manufacturer’s procedure or run the HVAC through full travel using the controls.
Most Common Failure Reasons
- Plastic Gear Wear Or Breakage: The most frequent cause — gears are made of plastic and can strip or fracture over time, especially when overloaded or after long service life.
- Motor Wear: Brushes or commutator wear leads to reduced torque or intermittent operation.
- Contamination And Moisture: Debris or water ingress into the heater box can accelerate wear or cause electrical faults.
- Overheating And Stiction: Stiff HVAC linkages or seized flaps increase load on the motor and cause premature failure.
- Electrical Issues: Connector corrosion or wiring faults can prevent proper motor operation.
Compatibility And Fitment Tips
- Fits First‑Generation Peugeot 3008 and 5008 models (ensure actuator location and connector type match your vehicle).
- Part numbers commonly used to search for this motor: P1975001, 647995, EAD516 — check these against your part listing.
- Unit Supplied As Motor Only: Verify you have the original gear carrier available to transfer, or obtain the compatible gear set before installation.
Notes For Professionals
This product is aimed at professional technicians and competent DIYers. Follow vehicle manufacturer procedures for disassembly and reassembly. Always observe safe electrical practices when working on vehicle HVAC and electrical systems.
