Description
Steering wheel for Stellantis group vehicles. Covered in leather, very well preserved. Airbag connector is damaged.
This leather-covered steering wheel (part number 98210210ZD) is suitable for technicians and experienced DIY mechanics looking for an original replacement for multiple Stellantis platform vehicles. The part is often searched by its product code 98210210ZD and fits a range of small vans and MPVs. Please note the airbag connector is damaged and will require repair or replacement before the airbag circuit can function safely.
Features
- Leather-Covered Rim For Enhanced Grip And Interior Appearance
- Original Equipment Part Number: 98210210ZD
- Very Good Cosmetic Condition On The Wheel Surface
- Airbag Connector Damaged — Requires Repair/Replacement
- Suitable For Mechanics And Experienced DIY Installers
Technical Information
- Manufacturer: Stellantis
- Model(s): Citroën Berlingo K9; Peugeot Rifter; Fiat Doblo III; Opel Combo E K9; Toyota ProAce City
- Product Codes: 98210210ZD
- Other Numbers: Not Available
Installation Recommendations
Follow proper safety procedures when working with steering wheels and airbag systems. Recommended steps:
- Disconnect the negative battery terminal and wait at least 10 minutes to allow the airbag system to discharge.
- Mark the steering wheel position relative to the steering column to preserve alignment.
- Remove the airbag module according to the vehicle’s procedure (access points typically on the back of the wheel), then carefully disconnect airbag and horn connectors. Be aware the airbag connector on this unit is damaged and must be addressed before reconnection.
- Loosen and remove the central retaining nut and use a steering wheel puller if the wheel does not come off by hand.
- Inspect the clockspring (spiral cable) and wiring for wear or damage; replace if any defects are found.
- Refit the wheel in the marked position, torque the central nut to the manufacturer’s specification, reconnect all connectors, and reconnect the battery. Verify correct function of horn and airbag warning light after reassembly.
Why This Part Fails Most Often
- Cosmetic Wear: Leather can degrade from use, sweat, oils and UV exposure, causing cracking or discoloration.
- Connector Damage: Airbag connectors are often damaged during removal or as a result of previous collisions; broken pins or housing prevent a reliable airbag connection.
- Mechanical Stress: Improper removal without a puller or incorrect handling can bend splines or damage the wheel hub interface.
- Related Component Failure: A faulty clockspring or damaged wiring harness can cause electrical problems attributed to the steering wheel.
Recommendation: Repair or replace the damaged airbag connector and inspect the clockspring before installation. If you are uncertain about any step, have the work performed by a qualified technician who has experience with airbag systems and the appropriate safety equipment.
