Description
Floor Console Panel For First Generation Peugeot 3008 And 5008. Color HYC – NIXON
Used center console trim designed for the gear selector area of Peugeot 3008 I and Peugeot 5008 I. This original OEM panel (interior trim) restores the factory appearance around the shifter, hides mounting points and wiring, and integrates with adjacent trim pieces. Ideal for mechanics and DIY enthusiasts looking to replace cracked, faded or damaged trim without replacing the complete console assembly. Common search terms: Peugeot 3008 gear shift console panel, Peugeot 5008 center console trim, 98071852YC, 9807185277.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 3008 I, Peugeot 5008 I
- Product Codes: 98071852YC, 9807185277
- Other Numbers: OEM Interior Part For Center Console / Gear Selector Area
Fitment And Function
The panel fits the first generation Peugeot 3008 and 5008 center console around the gear lever. It functions as the decorative and protective surround for the shifter, secures adjacent trim pieces, and may house switches or trim inserts depending on the specific vehicle specification. Fitment is OEM-based — match the product codes above with the part being replaced for correct alignment and clip positions.
Installation Recommendations
- Disconnect The Battery Before Starting Work To Avoid Accidental Short Circuits When Disconnecting Any Electrical Connectors.
- Remove The Gear Knob (Follow Manufacturer Procedure For Your Variant; Some Knobs Tighten, Others Use A Retaining Clip Or Screw).
- Unscrew Any Visible Fasteners And Use Plastic Trim Tools To Carefully Release Hidden Clips To Prevent Breakage.
- Disconnect Any Electrical Connectors For Switches Or Illumination Before Fully Removing The Panel.
- Transfer Any Switches, Bezel Inserts Or Insulation Pads From The Old Panel To The Replacement If Required.
- Reassemble In Reverse Order, Check Switch Functionality And Alignment Before Final Clip Engagement.
- Use Gentle, Even Force When Engaging Clips; Damaged Clips Are A Common Cause Of Rattles And Poor Fitment.
Why This Part Commonly Fails
- Cosmetic Wear: Surface Scratches, Fading From Sunlight, And Stains From Liquids Or Chemicals.
- Mechanical Damage: Broken Mounting Tabs Or Clips During Rough Removal/Installation Or After Impact.
- Plastic Fatigue: Repeated Use, Heat Cycling And Age Can Cause Cracks Around The Shifter Opening.
- Contamination: Spilled Fluids Can Soak Into Trim Joints And Affect Appearance Or Attached Components.
Notes For Buyers
This Is A Used OEM Panel; Expect Typical Signs Of Use Such As Minor Surface Wear Or Small Clip Marks Unless Otherwise Stated In Listing Photos. Verify That The Part Codes Match Your Vehicle’s Existing Panel For Best Fitment. Suitable For Professional Workshops And Knowledgeable DIYers Comfortable With Interior Trim Removal.
