Description
Right rear lamp for Citroën C1, may also fit Peugeot 107
Passenger Side
Without Bulb Sockets
Original Part
Product Overview
This right-hand rear lamp (passenger side) is an original equipment part designed for Citroën C1 and commonly compatible with Peugeot 107. Supplied without bulb sockets, the unit replaces the complete rear light assembly and carries original part references for easy lookup: 81550-0H060 / 81550-060 / 6351X8. Ideal for professional workshops and experienced DIY mechanics who require a direct-fit OE solution.
Key Benefits
- Direct Replacement: Original part geometry and mounting points ensure a precise fit and straightforward installation.
- Durable Construction: Designed to OEM specifications for consistent light output and weather sealing.
- Quick Identification: Commonly searched by OE codes (81550-0H060, 81550-060, 6351X8) for fast part finding.
- Cost Effective Repair: Replacing the full lamp body restores appearance and safety after impact or water damage.
Compatibility
Designed for:
- Citroën C1 (rear, right / passenger side)
- Peugeot 107 (possible fit, verify physical match)
Technical Information
- Manufacturer: Stellantis (Citroën / Peugeot)
- Model: Citroën C1; Peugeot 107 (possible)
- Product Codes: 81550-0H060, 81550-060
- Additional Numbers: 6351X8
Function And Notes
The rear lamp assembly houses brake, tail and indicator lamp functions depending on bulb configuration. This listing is for the lamp body only and does not include bulb sockets or bulbs. Ensure the correct bulb types are installed and that electrical connectors are clean and intact to maintain reliable operation and road safety.
Replacement Procedure (General Guide)
- Prepare Tools: Basic tools typically include a screwdriver set, trim removal tool and a 10 mm socket or appropriate screwdriver for tailgate/trim fasteners.
- Safety First: Disconnect the battery before starting electrical work to prevent short circuits.
- Remove Interior Trim: Access the rear lamp fasteners from inside the luggage compartment by removing the trim panel or covers.
- Unbolt Lamp Assembly: Unscrew the retaining bolts and carefully pull the lamp away from the body to expose the electrical connector(s).
- Disconnect Connector(s): Release the clip and unplug the wiring harness. Remove the old lamp assembly.
- Fit New Lamp: Position the replacement lamp, reconnect the wiring harness and secure the assembly with original fasteners.
- Test Functionality: Reconnect the battery and test all lamp functions (tail, brake, indicator, reverse if applicable) before reassembling interior trim.
Installation Recommendations
- Always Disconnect The Battery Before Starting Work To Avoid Short Circuits.
- Check Connectors For Corrosion And Bent Pins; Clean Or Replace As Necessary.
- Use Correct Torque On Mounting Bolts To Prevent Cracking Of Plastic Tabs.
- Seal Bodywork Edges If Water Ingress Is A Concern; Replace Gaskets Or Seals When Damaged.
- Verify Bulb Types And Fitment Since This Unit Is Supplied Without Bulb Sockets.
Most Common Failure Reasons
- Water Ingress: Damaged seals or cracked lens allow moisture into the lamp, causing corrosion of contacts and reduced lighting performance.
- Impact Damage: Rear collisions or minor bumps often crack the lens or break mounting tabs, requiring full assembly replacement.
- Connector Corrosion: Road salt and moisture corrode the electrical connector, leading to intermittent or lost function.
- Aging And UV Exposure: Long-term exposure can cause plastic fading, seal hardening and eventual leakage.
Final Notes
When ordering, refer to OE codes 81550-0H060 / 81550-060 / 6351X8 to improve search accuracy. This original lamp assembly restores factory fit and finish and is recommended when the lens or mounting points are compromised.
