Description
Original right rear wing tail light for Citroën C3 II (A51). Without bulb holders; these can be purchased separately. Passenger side.
Product Description
This genuine right rear wing tail light is designed for the Citroën C3 II (A51) and replaces the factory lamp on the passenger side. The unit is supplied without bulb holders, allowing you to reuse the original sockets or fit new holders and bulbs as needed. Ideal for professional workshops and DIY enthusiasts looking for an exact-fit replacement that restores original appearance and lighting function.
Key Benefits
- Direct OEM fit for Citroën C3 II (A51) — ensures correct alignment and sealing.
- High-quality lens and housing for optimal light output and durability.
- Sold without bulb holders so you can reuse existing components or upgrade bulbs separately.
- Often searched by product codes 9673805380 and 6351KQ — quick lookup for mechanics and parts specialists.
Technical Information
- Manufacturer: Citroën / Stellantis
- Model: Citroën C3 II (A51)
- Product Codes: 9673805380, 6351KQ
- Other Numbers: 9673805380 | 6351KQ
Installation Recommendations
Installation is straightforward for experienced technicians. General steps:
- Access the rear lamp from inside the trunk or by removing the inner wheel-arch liner, depending on vehicle trim.
- Remove retaining screws or clips and carefully detach the lamp assembly, watching for plastic mounting tabs.
- Unplug the electrical connector and remove the old lamp. Fit the new lamp, connect the wiring and check alignment.
- Install bulb holders and bulbs if required, then test all light functions (tail, stop, indicator, reverse) before final reassembly.
- Always handle the lens carefully to avoid scratches. Replace any damaged mounting clips to ensure secure fitment.
Why This Part Fails
The most common causes of tail light failure are moisture ingress leading to condensation and corrosion of contacts, cracked or damaged lens from impacts, broken mounting tabs from stress or previous poor installations, and connector or wiring corrosion. Bulbs and bulb holders are also frequent failure points — note that this unit is supplied without bulb holders.
Notes For Mechanics And DIYers
- Search by OEM codes 9673805380 or 6351KQ for fast identification.
- Check mounting tabs and sealing surfaces when fitting to prevent future water ingress.
- Replace bulbs and holders if they show signs of wear or corrosion to ensure reliable operation.
