Description
Socket For The Left Rear Lamp For PEUGEOT 308 T7 SW. Fully Functional, Bulb Functionality Not Tested. Comes With A Piece Of Wiring. Driver’s Side.
Product Overview
This replacement socket and partial wiring harness is designed for the left rear lamp of the Peugeot 308 T7 SW. It provides a direct connection point for tail, brake and indicator bulbs and simplifies replacement of a damaged lamp holder without the need to replace the complete lamp assembly. The part is commonly searched under the product code 6350KW.
Why Choose This Part
Ideal for professional workshops and DIY enthusiasts — the part saves time and money when the original socket or short section of cabling is corroded, broken or heat-damaged. Supplied with a piece of wiring, it helps ensure a reliable electrical connection and faster installation compared with repairing the original wiring on-vehicle.
Replacement Guide
Basic steps to replace the socket on a Peugeot 308 SW:
- Park the vehicle safely, switch off ignition and disconnect the negative battery terminal.
- Open the tailgate and remove inner trim panels to access the lamp cluster fastenings.
- Unbolt or unclip the rear lamp assembly and gently pull it out to reach the socket.
- Disconnect the old socket from the wiring harness and remove any retained clips or seals.
- Fit the new socket and mating wiring section, ensure snug, corrosion-free connections and secure with clips or tape as required.
- Reinstall the lamp assembly, test light functions, reattach trim and reconnect the battery.
Installation Recommendations
Always disconnect the battery before starting electrical work. Make sure connectors and contacts are clean and free of corrosion; use dielectric grease on contacts to reduce future corrosion. Replace bulbs if their condition is uncertain — bulb failure can be mistaken for socket or wiring faults. Secure any exposed wiring against chafing and moisture ingress using appropriate clips and seals.
Most Common Failure Reasons
- Corrosion On Contacts: Moisture ingress in the lamp cluster causes oxidized contacts and poor electrical connection.
- Heat Damage: Repeated bulb heat cycles or poor ventilation can deform plastic sockets over time.
- Mechanical Stress And Vibration: Movement of the lamp assembly or damaged mounting points can break the socket or wires.
- Wiring Abrasion Or Short Circuits: Chafed insulation or damaged wiring leads to intermittent faults or complete failure.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 308 T7 SW
- Product Codes: 6350KW
- Additional Numbers: NFP
Compatibility Note
This socket is intended for the left rear lamp on Peugeot 308 T7 SW models. It is often sought by its product code 6350KW — check vehicle model and lamp type to confirm fitment before purchase.
