Description
Headlight Washer Nozzle And Cap For PEUGEOT 307
Right Side – Headlamp In Front Of Passenger
Color EZW – Paint Grey (Fer)
Product Overview
High-quality replacement headlight washer nozzle and painted cap designed for the right front headlamp of the Peugeot 307. This direct-fit component restores proper washer spray pattern and maintains the original exterior appearance thanks to the EZW grey painted finish. Ideal for professional workshops and DIY mechanics who need a reliable, visually matched part after minor collisions, bumper repairs or when the original nozzle becomes clogged or damaged.
Key Benefits
- Direct Fit: Designed to match factory geometry for a secure, watertight installation and correct spray alignment.
- Painted Cap: Supplied in EZW grey to blend with factory paintwork, eliminating the need for repainting in many cases.
- Easy Serviceability: Accessible replacement that can be fitted without replacing the whole bumper or headlamp assembly in most cases.
- Workshop Friendly: Useful spare for technicians performing front-end repairs or cosmetic restoration on Peugeot 307 vehicles.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 307 (Right Front Headlamp Washer)
- Product Codes: 6438H3, 6438H1
- Other Numbers: Color Code EZW (Grey)
Compatibility And Fitment Notes
Fits Right Hand Side (Passenger Side) headlamp washer position on Peugeot 307 models. When ordering, verify the part code (6438H3 or 6438H1) and color code (EZW) to ensure match with the vehicle’s bumper finish. This nozzle assembly is intended to replace the damaged or clogged original unit and restore correct washer function and appearance.
Installation Recommendations
Suitable for experienced technicians and competent DIYers. Typical replacement steps:
- Park Vehicle On A Level Surface And Switch Off Ignition.
- Activate The Washer System To Empty Residual Fluid And Reduce Pressure.
- Access The Nozzle From Under The Bumper Or Through The Wheel Arch Liner Depending On Vehicle Version. Some Vehicles Allow Removal From Front Without Bumper Removal.
- Release Retaining Clips Or Fasteners Holding The Nozzle, Carefully Disconnect The Washer Hose.
- Fit The New Nozzle And Cap, Reattach Hose And Ensure A Secure Clip Engagement.
- Refill Washer Reservoir If Required And Test Spray Pattern And Sealing For Leaks.
Use trim tools to avoid scratching surrounding paint. If the cap is painted, handle carefully to preserve the finish. Replace sealing grommets if brittle or damaged.
Why This Part Fails Most Often
- Impact Damage: Commonly broken or cracked in low-speed collisions or when the bumper is struck.
- Clogging And Blockage: Dirt, road salt and debris can block the nozzle or the connecting hose, degrading spray performance.
- Freezing And Thermal Stress: Water trapped in the nozzle can freeze and fracture plastic components in cold climates.
- Wear And Ageing: UV exposure and mechanical wear can make clips and seals brittle, leading to leaks or loss of fitment.
Practical Tips
- Inspect Hoses And Pump If Poor Spray Persists After Replacement — A Faulty Pump Or Collapsed Hose Can Mimic Nozzle Failure.
- Clean The Washer Fluid Filtration Screen During Service To Reduce Future Blockages.
- When Replacing After A Collision, Check Surrounding Mounting Points For Deformation To Ensure Proper Alignment.
- Test The Nozzle Adjustment And Spray Pattern After Installation; Minor Aim Adjustments May Be Required.
Recommendation
For best results, fit this part during routine front-end repairs or when addressing headlight washer faults. Professional installation is recommended when bumper removal is required or when precise alignment is critical to restore OEM spray coverage and appearance.
