Description
Bulb holder for the right rear lamp with a piece of wiring for Citroën C1 and Peugeot 107. Functionality of the bulbs themselves is not guaranteed.
Product Overview
This replacement bulb holder with an attached wiring pigtail is designed for the right rear lamp assembly on Citroën C1 and Peugeot 107 vehicles. It restores the electrical connection between the vehicle harness and the lamp sockets, providing a quick repair option for broken sockets, damaged leads or corroded contacts. Ideal for professional workshops and DIY mechanics who search by part number to ensure compatibility.
Key Features
- Direct fit for right rear lamp application on Citroën C1 and Peugeot 107 (first generation).
- Includes socket(s) and a piece of wiring for straightforward replacement of the damaged harness section.
- Supplied without bulbs; the functionality of bulbs is not guaranteed.
- Often stocked and searched by OE/product codes for fast identification.
Technical Information
- Manufacturer: Stellantis
- Model: Citroën C1 (First Generation), Peugeot 107
- Product Codes: 634681, 81550-0H060, 6351X8, 6351X6
- Additional Numbers: 634681, 6351X6, 6351X8, 81550-0H060
Installation Recommendations
Follow safe working practices and vehicle-specific procedures when replacing the lamp holder. Recommended steps:
- Disconnect the vehicle battery before starting work to avoid short circuits or damage to electrical components.
- Access the right rear lamp assembly from the boot/compartment: remove trim panels and unscrew the lamp housing fasteners.
- Remove the lamp assembly and access the old socket/wiring. Unplug any connectors and rotate or unclip the socket to release it from the housing.
- Fit the new holder, route the pigtail to avoid sharp edges, and secure any retention clips or grommets to maintain sealing against moisture.
- Reconnect connectors, reassemble the lamp and test all functions (tail, stop, indicator) before reattaching trim panels.
- Use dielectric grease on contacts to reduce corrosion risk and ensure a reliable connection.
Why This Part Fails
- Moisture Ingress: Water entry into the lamp housing causes corrosion of contacts and connectors.
- Heat Damage: High operating temperatures or incorrect bulb wattage can melt plastic sockets or deform contacts.
- Mechanical Stress: Vibration, impact, or repeated bulb changes can crack the plastic or loosen contacts.
- Electrical Contact Wear: Oxidation and loss of spring tension in contacts lead to intermittent or non-functioning lights.
How Replacement Is Performed
The bulb holder is typically replaced by removing the tail lamp assembly, disconnecting the old socket from the lamp and harness, and installing the new holder into the lamp housing. Reassembly is straightforward: secure the lamp, reconnect the battery, and verify all rear light functions. If corrosion or wiring damage extends beyond the holder, additional harness repairs may be necessary.
Practical Notes
- Searches for this part are often performed using the product codes listed above—use them to speed up identification.
- Bulbs are not included and their operation is not guaranteed with this part; check and replace bulbs if required.
- If the lamp housing shows signs of cracking or heavy moisture ingress, replace or reseal the housing to prevent repeat failures.
