Description
Sun visor for Citroën Berlingo II and Peugeot Partner II. This is a used item; it may be slightly dirty. Left side – Driver.
High-quality used driver-side sun visor suitable for Citroën Berlingo II and Peugeot Partner II. Ideal for professional mechanics and DIY enthusiasts searching by part number (8143TG, 1618180980). The visor restores proper sun protection and cabin comfort, reduces glare while driving and replaces worn or damaged original equipment. Supplied as shown — minor signs of use and light soiling are possible.
Technical Information
- Manufacturer: Stellantis (Citroën / Peugeot)
- Model: Citroën Berlingo II; Peugeot Partner II
- Product Codes: 8143TG, 1618180980
- Additional Numbers: 1618180980 | 8143TG
- Position: Left Side (Driver)
Installation Recommendations
Replacement is straightforward for experienced technicians and competent DIYers. Typical steps:
- Fold visor down and locate retaining screws or clips (often hidden under plastic covers).
- Carefully pry off any trim caps, remove screws and release the pivot/retaining clips.
- If the visor is equipped with a vanity mirror light, disconnect the electrical connector before removal.
- Fit the replacement visor by aligning the pivot and securing screws/clips; ensure smooth operation of the hinge.
Use common hand tools (trim pry, Phillips/torx screwdriver depending on vehicle) and avoid excessive force to prevent damage to headliner or trim. If electrical connections are present, isolate the circuit or disconnect the battery before work to avoid short circuits.
Most Common Reasons For Failure
Sun visors typically fail due to mechanical wear or external damage. Common causes include:
- Worn or broken pivot mechanism and retaining clips—resulting in loose or sagging visor.
- Torn or delaminated fabric and foam from long-term sun exposure and heat.
- Impact or interior collision damage (e.g., during door loading or accident).
- Staining and soiling from frequent handling, smoke or grease.
Replacing a damaged visor restores driver comfort and visibility. For workshop fitting, inspect the mounting points and clips and replace any brittle fasteners to ensure a secure, long-lasting installation.
