Description
Seat Belt CITROËN C4 Grand Picasso Left Rear Seat In Third Row
Description
Used left rear seat belt assembly for the third-row seat of the Citroën C4 Grand Picasso. Designed as a direct replacement for the original equipment on 7‑seater Grand C4 Picasso models, this assembly includes the retractor and mounting interfaces required for the left position in the third row. Ideal for professional workshops and home mechanics searching by part number (9654454477, 8974XW).
Fitment
Compatible With: Citroën C4 Grand Picasso / Grand C4 Picasso models equipped with a third row (left rear position). Always verify the part numbers below against your vehicle’s paperwork or parts list to ensure correct fitment for the model year and trim.
Technical Information
- Manufacturer: Citroën / Stellantis
- Model: C4 Grand Picasso (Third Row, Left Rear)
- Product Codes: 9654454477
- Additional Numbers: 8974XW
Installation Recommendations
Always follow vehicle manufacturer procedures. Recommended installation steps for experienced technicians or knowledgeable DIYers:
- Disconnect the vehicle battery and wait several minutes before starting work to reduce the risk of accidental pretensioner activation.
- Remove interior trim panels carefully to access the retractor, anchor bolts and buckle. Keep trim clips and fasteners organized for reassembly.
- Unbolt the mounting hardware securing the retractor and lower anchors. Remove the old assembly and compare mounting points to the replacement before fitting.
- Install the new belt assembly, route the webbing correctly through any guides, and secure all bolts. Tighten fasteners to the manufacturer’s torque specifications.
- Check that the webbing runs freely and the retractor locks under a sharp pull; verify buckle operation and secure latching.
Most Common Failure Causes
- Pretensioner Deployment: Pyrotechnic pretensioners activate in an impact and must be replaced after deployment.
- Wear And Damage To Webbing: Fraying, cuts or abrasion from long-term use, improper routing or sharp edges.
- Retractor Malfunction: Internal spring or locking mechanism can seize due to contamination, corrosion or mechanical wear.
- Buckle Or Release Failure: Dirt, foreign objects or mechanical damage can prevent correct latching or release.
- Corroded Mounting Points: Bolts and anchor plates can corrode in regions with heavy road salt, compromising fastening integrity.
Notes
This is a replacement part intended for repair and safety restoration. After installation, perform a functional check of the belt and retractor. If there is any doubt about the condition of the pretensioner or the integrity of mounting points, use a qualified technician for assessment and installation.
