Description
Rear centre seat belt for PEUGEOT 407. Colour FXX Black.
Ensure safe rear passenger restraint with this original-equipment style rear centre seat belt for the Peugeot 407. Designed as a direct-fit replacement referenced by part numbers 96440737XX and 8974HL, this belt restores proper occupant protection and retractor function in the middle rear seating position. Ideal for professional workshops and competent DIY mechanics searching by part number, the listing includes useful technical details and clear installation guidance to speed up fitment.
Key Features
- Direct replacement for the Peugeot 407 rear centre seating position (middle rear).
- Colour: FXX Black — matches original interior trim for discreet appearance.
- Reference numbers commonly used in searches and catalogs: 96440737XX, 8974HL.
- Built to interface with factory mounting points and anchor brackets.
Suitable For / Compatibility
Primarily intended for Peugeot 407 models — fits vehicles that use the OEM part numbers listed above. When searching or ordering, use the product codes (96440737XX / 8974HL) as the main reference to confirm fitment for your vehicle variant (Saloon/SW where applicable).
Function And Common Faults
The rear centre seat belt secures the middle rear occupant and is a critical part of the passive safety system. Typical failure modes include:
- Webbing Wear Or Fraying: Long-term abrasion, contamination (dirt/oils), or UV exposure can degrade the fabric and reduce effectiveness.
- Retractor Jamming Or Failure: Dirt ingress, corrosion or internal spring/retractor wear can prevent proper extension and retraction or cause the locking mechanism to stick.
- Mounting Hardware Corrosion Or Damage: Bolts and anchor points can corrode or be deformed after an accident, compromising secure attachment.
- Contamination Or Twisting: Twisted webbing or foreign objects can prevent correct retraction and locking.
Installation Recommendation
Designed to be fitted by an experienced mechanic or a confident DIYer with the correct tools. High-level replacement steps:
- Remove the necessary trim panels to access the retractor, top anchor and lower anchor bolts.
- Unbolt the old belt assembly from the vehicle anchor points and detach any guides or fasteners.
- Install the new belt in reverse order, ensuring the webbing is routed correctly through guides and the retractor is seated squarely.
- Tighten all bolts to the manufacturer’s specified torque (refer to the Peugeot service manual for exact values).
- Check operation: fully extend and retract the belt, and verify the locking mechanism engages under a sharp tug.
Safety Notes: If the vehicle is equipped with belt pretensioners or other SRS components linked to restraints, follow the manufacturer’s safety procedure (disconnect the battery and observe the recommended wait time) before starting work. Use torque-controlled tools and replace any damaged anchor bolts or trim clips.
Why This Part Fails Most Often
Rear centre belts often fail through wear and contamination or due to retractor mechanism faults. Middle seats are frequently used for short journeys and can accumulate dirt and foreign particles in the retractor, while accidental loading or previous collisions can damage anchors or internal components. Regular inspection after an impact and replacing belts that show fraying, poor retraction, or locking faults is essential for continued occupant safety.
Technical Information
- Manufacturer: Peugeot (Stellantis)
- Model: Peugeot 407
- Product Codes: 96440737XX, 8974HL
- Additional Numbers: NFP (as listed in short reference)
- Colour: FXX Black
- Position: Rear Centre (Middle Rear)
Recommendation For Fitment
- Use the OEM part numbers provided when ordering to ensure correct match.
- Replace any damaged mounting hardware and recheck torque after first use.
- After installation, verify full belt travel, locking response and that the belt lies flat without twists.
