Description
Right passenger exterior mirror for Peugeot 206. Color KTH – Painted Thorium Gray. Slightly scuffed.
Product Overview
This right-hand (passenger side) exterior mirror is a direct-fit replacement for Peugeot 206 models and compatible variants such as the 206+. Finished in KTH Thorium Gray paint, the unit restores exterior appearance and mirror functionality. Ideal for professional workshops and DIY mechanics looking for a cost-effective body repair part that matches original equipment styling and fitment.
Features And Function
- Replacement mirror assembly for passenger (right) side of the vehicle.
- Painted Finish: KTH (Thorium Gray) to match factory body color.
- Includes mounting points and wiring interface for powered/heated variants where applicable.
- Typical functions: manual or electric adjustment, possible heating element depending on original equipment.
Technical Information
- Manufacturer: Stellantis (Peugeot/Citroën)
- Model: Peugeot 206, Peugeot 206+
- Product Codes: 96432613XT, 96437171XT
- Additional Numbers: 8148XY, 8154JC, KTH
- Side: Right (Passenger)
- Color: KTH – Thorium Gray
- Condition Note: Slightly Scuffed
Fitment And Compatibility
Fitment is intended for Peugeot 206 series vehicles and commonly referenced under the above product codes. Always confirm that the part numbers match those of the original mirror on the vehicle. This unit follows OE-style mounting and should align with factory door brackets on compatible models.
Installation Recommendations
- Preparation: Gather Torx/screwdriver set and trim tools. Work on a clean, dry surface and protect painted panels.
- Electrical Safety: If the mirror has electrical functions (adjustment/heating/folding), disconnect the negative battery terminal before unplugging electrical connectors to avoid shorts.
- Removal: Lower window for access if required. Remove interior triangular trim or cover on the door, disconnect the mirror electrical connector, then remove the mounting fasteners (usually three bolts). Carefully support the mirror during removal to avoid dropping and damaging the door skin or trim.
- Installation: Position the replacement mirror, loosely fit fasteners, connect the electrical plug, test all electrical functions (adjustment, heating, folding) before fully tightening fasteners, then re-fit interior trim.
- Adjustment: After installation, adjust mirror glass to driver’s view and check for wind noise at speed. Ensure seals and gaskets are seated to prevent water ingress.
Why This Part Fails Most Often
- Impact Damage: Collisions or side-swipes are the most frequent cause—physical breakage or bent mounting points.
- Wear On Internal Mechanism: Electric motors and gearing can wear out over time, especially with frequent adjustment or folding.
- Water Ingress And Corrosion: Moisture entering through damaged seals can corrode connectors and motors, causing intermittent or permanent failure.
- Glass Damage: Stones or direct impacts can crack the mirror glass while the assembly remains otherwise intact.
- Cosmetic Wear: Paint chipping or scuffs (as noted on this unit) usually result from minor impacts or abrasion and do not affect mechanical function.
Maintenance Tips
- Regularly check mirror seals and door trim for gaps that could allow water entry.
- Operate electric mirror functions occasionally to keep internal gears lubricated and prevent seizure.
- Address paint chips quickly to prevent corrosion on metal components.
Notes For Professionals
This part is suitable for fitment by experienced technicians and competent DIYers. Verify part numbers from the door mirror label or original part reference before installation to ensure correct variant (heated, electric, folding or manual) is fitted.
