Passenger passport holder Citroën C1 Peugeot 107 8974LQ 8976N7

Description

Passenger passport holder for Citroën C1 Peugeot 107 cars of the first series
No alarm

Part description

This used passenger passport holder is designed for Citroën C1 and Peugeot 107 cars. It is an important part of the interior and of the seat belt system, which ensures proper fastening and functional guidance of the belt during normal use of the vehicle.

The part is particularly suitable for repairing a damaged or worn original piece. When looking for the right spare part, it is practical to follow the product numbers listed below.

Technical information

• Manufacturer: Stellantis Citroën Peugeot
• Model: Citroën C1, Peugeot 107
• Other numbers: 8974LQ, 8976N7

Product codes

• Product codes: 8974LQ, 8976N7
• Models from labels: Citroën C1, Peugeot 107

Installation recommendations

It is generally true for this type of part that the exact replacement procedure may vary depending on the specific design of the car’s interior. It is important to proceed carefully with the seat belt holder so that the function of the belt is not restricted or there is play in the attachment after assembly.

1) Before assembly

• Check whether the used part is not cracked, deformed or mechanically damaged.
• Compare the new and original piece by shape, fit, orientation and product numbers.
• Check the condition of the surrounding fastening points and connected parts of the interior.
• If there is a seat belt around, check that it is not frayed, twisted or otherwise damaged.

2) Necessary tools and materials

• ordinary hand tools for dismantling interior elements
• plastic pry bar for upholstery
• suitable keys or bits according to the type of fastener
• cleaning agent for cleaning contact surfaces
• clean rag

3) Step-by-step assembly procedure

1. Park the vehicle in a safe place and secure it against movement.
2. If necessary, remove the covering or upholstered parts of the interior that prevent access to the holder.
3. Carefully release the original passport holder and check how it fits.
4. Compare the dismantled part with the used spare part, especially the shape, attachment and orientation.
5. Clean the installation site from dirt, dust and any remnants of the original part.
6. Place the replacement bracket into the correct position without force and check that it fits the same as the original piece.
7. Install the fasteners and tighten them evenly so that the bracket fits tightly and there is no tension.
8. If the surrounding interior part or belt guide has been removed, return everything to its original position.
9. Check the free movement of the belt at the place of the holder and verify that it does not rub or twist anywhere.
10. Refit all covers and trim.
• 4) Post-assembly checks and test drive/function verification
  • Verify that the bracket is firmly seated and has no play.
  • Check that the seat belt passes correctly and without snagging.
  • Try putting the belt on and off repeatedly while sitting normally in the passenger seat.
  • During a short test drive, observe whether there are any noises from around the assembly.

  5) The most common assembly mistakes + how to avoid them

  • Part exchange – always compare 8974LQ and 8976N7 numbers and design.
  • Upholstery damage – use appropriate tools for interior plastics.
  • Overlooking belt damage – always check the connected parts before final assembly.
  • Insufficient function check – always test for smooth movement and correct belt guidance after assembly.

  Reasons why the part is damaged

  • normal wear and tear from everyday seat belt use
  • mechanical stress during careless entry and exit
  • cracking of plastic parts due to the age of the material
  • damage after dismantling the interior or unprofessional repair
  • deformation or breakage after an impact or heavy load on the belt