Description
Lock for the right front door for Peugeot 207 hatchback and estate. Front passenger door.
Product Overview
Robust right front door lock assembly designed for Peugeot 207 (hatchback and SW/estate). This unit secures the front passenger door and integrates with the vehicle’s central locking system. Commonly searched by OE references and part numbers, the lock is suitable for professional workshops and experienced DIY mechanics looking for a direct-fit replacement without modifications.
Technical Information
- Manufacturer: Stellantis (Peugeot/Citroën)
- Model: Peugeot 207 (Hatchback, SW / Estate)
- Product Codes: 24094158, 24095158, 24093158
- Additional Numbers: 9136W6
Function And When It Fails
The door lock assembly latches and secures the door, provides the mechanical interface for the interior/exterior handles and works with the central locking actuator and vehicle alarm. Failures typically result in a door that will not lock/unlock properly, a handle that feels loose or does not return, or intermittent central locking operation.
Most Common Reasons For Failure
- Mechanical Wear: Worn pawls, gears or latch components due to long-term use.
- Corrosion and Water Ingress: Moisture penetration causes rust or seizing of moving parts.
- Broken Plastic Parts: Internal plastic components or guides can crack, causing poor engagement.
- Actuator Problems: If the lock includes an electric actuator, motor or internal contacts can fail.
- Linkage/Cable Damage: Rods or cables from handles can detach or bend, preventing proper operation.
Installation Recommendations
- Preparation: Park on a level surface, set the vehicle in park/neutral and engage the handbrake. Gather basic tools (panel trim tools, Torx/Sockets, screwdriver set).
- Electrical Safety: Before disconnecting electrical connectors, disconnect the negative battery terminal to avoid short circuits when working near powered components.
- Remove Door Trim: Carefully pry off the door card and remove any moisture barriers to access the lock mechanism. Keep fasteners and clips organized.
- Disconnect Linkages and Connectors: Note the position of rods/cables and electrical plugs. Mark or photograph their routing to ensure correct reassembly.
- Remove Old Lock: Unscrew the lock module from the door and extract it through the service opening. Transfer any necessary clips, rods or catch plates to the new unit if required.
- Fit New Lock: Install the new lock assembly, reconnect rods/cables and electrical connectors, and secure all fasteners to the manufacturer’s torque where applicable.
- Test Operation: Reconnect the battery, test mechanical locking/unlocking, inside and outside handles, and central locking function before reinstalling the door card.
- Final Check: Ensure smooth operation across full door travel and that the door closes and latches without excess force. Replace any damaged sealing or insulation to prevent future water ingress.
Practical Tips
- Take photos during disassembly to simplify reassembly of linkages and clips.
- Use white lithium grease or light spray lubricant on latch points after installation to improve longevity.
- If central locking behaves erratically after replacement, verify connector pins and earth points are clean and secure.
- Allow approximately 30–60 minutes for a professional swap, longer if the door card or clips are difficult to remove.
Search And Compatibility
This part is frequently located by its OE numbers (24094158, 24095158, 24093158, 9136W6) when searching online or in parts catalogs. Always confirm that the part number matches the required reference for the vehicle model and door position before fitting.
