Description
This Sanden SD7C16 air conditioning compressor (part numbers 9660555280, 1332F, 6453XC) is a direct-fit type commonly used on selected PSA vehicles. Designed for professional workshops and competent DIY mechanics, it provides reliable cooling performance for vehicle HVAC systems when installed and serviced according to manufacturer guidelines. Listing key part numbers in the description improves findability for searches by code.
Features And Benefits
The SD7C16 design delivers efficient compression in medium-duty passenger cars. Key attributes include:
- Original Sanden SD7C16 architecture for PSA applications.
- 6-rib pulley compatible with standard accessory drive configurations.
- Pulley diameter: 119 mm.
- Oil fill: 135 ml of PAG 46 compressor oil.
- Three mounting points for secure installation.
- Net Weight: Approximately 6.1 kg.
Compatibility
Commonly fitted to PSA Group vehicles. Typical compatible models include Citroën C5 III and Peugeot 407, but always verify compatibility by VIN or OEM part reference before purchase. Refer to the stamped and listed part numbers: 9660555280, 1332F, 1332, 6453XC and the Sanden SD7C16 model.
Installation And Service Guidance
Intended for mechanics and experienced DIYers. Follow these general steps and safety precautions:
- Have the vehicle’s refrigerant recovered by a certified technician before removal; do not vent refrigerant to atmosphere.
- Disconnect the battery to prevent electrical shorts.
- Remove the drive belt and any obstructing engine covers to access the compressor.
- Label and disconnect electrical connectors and refrigerant lines; be prepared to replace O-rings and seals.
- Unbolt the compressor from its mounts (three mounting points) and remove it carefully.
- Fit the replacement compressor, use new O-rings, and ensure correct alignment of the pulley and belt routing.
- Charge the compressor with the specified oil amount (135 ml of PAG 46) and follow the vehicle manufacturer’s procedure for vacuuming and recharging the system to the correct refrigerant type and pressure.
- After installation, test for leaks and verify clutch engagement and system pressures during operation. Follow OEM torque figures and service intervals when available.
Common Failure Modes And Causes
Understanding typical causes of compressor failure helps with diagnostics and preventive maintenance:
- Oil contamination or incorrect oil type can reduce lubrication and damage internal components.
- Seal and O-ring deterioration leads to refrigerant and oil leaks.
- Clutch or bearing wear results in noise, poor engagement or pulley seizure.
- System contamination (moisture, metal debris) from other failed components can accelerate compressor wear.
- Electrical faults or wiring/connectors failures can prevent clutch activation.
Technical Information
- Manufacturer: Sanden
- Model: SD7C16
- Product Codes: 9660555280, 1332F
- Other Numbers: 1332, 6453XC
Note: Always confirm vehicle compatibility by VIN or OEM reference before ordering. For safety and legal reasons, refrigerant recovery and recharging should be performed by certified personnel and in accordance with local regulations. When replacing the compressor, consider replacing the receiver/drier and inspecting the expansion device to ensure system longevity.
