Description
Valeo fan regulator for Citroën and Peugeot vehicles with wiring harness.
This used Valeo fan regulator is a direct-fit replacement part designed for the HVAC blower system in selected Citroën and Peugeot models. Supplied with a short wiring harness for easier installation, the unit is commonly referenced by the part numbers 6441L2, 6441P3 and 6442P3. Ideal for professional workshops and DIY mechanics who need a reliable blower speed control module to restore proper cabin ventilation.
Technical Information
- Manufacturer: Valeo
- Model: Citroën C2, Citroën C3, Citroën C3 Pluriel, Citroën C5, Peugeot 607
- Product Codes: 6441L2, 6441P3, 6442P3
- Additional Numbers: Stellantis / Citroën / Peugeot reference numbers commonly cross-referenced under the codes above
Function
The fan regulator controls the blower motor speed by modulating the electrical power delivered to the blower. Depending on design, the module uses electronic control (solid-state regulation) to provide multiple fan speeds and ensure smooth airflow control for heating, ventilation and air conditioning.
Common Symptoms Of A Faulty Regulator
- Blower Works Only On One Speed Or Not At All
- Intermittent Fan Operation Or Loss Of Some Speed Settings
- Unusual Smell Or Overheating Near The Glovebox/HVAC Area
- Electrical Noise Or Burning Smell When Fan Is Operated
Why This Part Fails Most Often
Failures are usually caused by heat stress, corrosion and moisture ingress, worn internal components or damaged connector/wiring. A failing blower motor (drawing excessive current) or clogged cabin filter leading to higher load can accelerate wear and cause the regulator to fail prematurely. Poor electrical contacts and short circuits are also common causes.
How Often It Fails
There is no fixed lifespan; longevity depends on vehicle usage, environment and maintenance. Typical failure occurrences are more frequent with high-mileage cars or where water ingress and corrosion are present. In many cases units last for many years, while others fail sooner if exposed to moisture or heavy electrical load.
Replacement Procedure (Overview)
Replacement is straightforward for a competent mechanic or experienced DIYer comfortable with dash disassembly:
- Disconnect Battery Before Starting Work.
- Access The Blower Housing (Often Via Glovebox Or Under-Dash Trim Depending On Model).
- Locate The Regulator Mounted To The HVAC Plenum Or Near The Blower Motor.
- Unplug The Electrical Connector And Remove Fasteners Securing The Regulator.
- Replace With The New Unit And Reconnect The Wiring Harness Securely.
- Reassemble Trim, Reconnect Battery And Test All Fan Speeds.
Installation Recommendations
- Always Disconnect The Battery Before Removing Or Installing The Unit To Prevent Electrical Damage.
- Inspect The Blower Motor And Cabin Filter; Replace If They Are Causing Excessive Current Draw.
- Check Wiring And Connector Pins For Corrosion Or Damage; Clean Or Repair As Needed.
- Ensure The Replacement Unit Is Securely Fastened And Wiring Is Routed To Avoid Chafing.
- After Installation, Verify All Fan Speeds And Listen For Unusual Noises Or Overheating.
Compatibility Notes
This regulator is commonly used on the listed Citroën and Peugeot models above. Always match product codes (6441L2 / 6441P3 / 6442P3) with the unit required for the vehicle to ensure correct fitment.
Additional Tips For Workshops
When replacing the regulator, consider checking the condition of the HVAC plenum seals and drainage paths to prevent future water ingress. If suspecting repeated failures, test blower motor current draw to rule out a failing motor imposing excess load on the regulator.







