Description
Fuel tank filler cap for CITROEN C3 II A51 cars
With filler neck box 1518E5
Color KDK – HICKORY BROWN LACQUER
Part description
This used fuel filler cap is intended for Citroën C3 II A51 cars. Also included is a filler box 1518E5, which is a practical solution when replacing a damaged or worn part. For many customers, matching the appearance is also important, which is why the KDK – Hickory brown color is an advantage.
The part is suitable for repairing the car after normal mechanical damage, wear of the hinge, breakage of the attachment or when replacing it for aesthetic reasons. When looking for the right part, the designation according to the product number is also decisive, so we recommend paying attention to the listed codes.
Technical information
Product codes
- Product codes: 1517H3, 1518E5, KDK
- Model names: Citroën C3 II A51, Citroën C3 III
Installation recommendations
Generally/typically for this type of body part, the exact method of replacement may vary depending on the specific design of the car and the mounting design. It is therefore always advisable to carefully compare the new and original part before assembly.
1) Before assembly
- Check whether the shape of the lid, attachment, hinges and connection to the filler neck box match.
- Compare numbers 1517H3 and 1518E5 with the original part if they are legible on your car.
- Check the condition of the paint, edges, latches and all attachment points.
- Make sure that the part is not cracked, deformed or otherwise damaged by transport or previous use.
2) Necessary tools and materials
- Basic set of hand tools
- Plastic pry bar or trim removal tool
- Clean cloth
- Preparation for cleaning contact surfaces
- Protective gloves
3) Step-by-step assembly procedure
- Open the filler neck lid area and ensure good access to the original part.
- Check carefully how the old lid and cabinet are attached to avoid damaging the surrounding plastic or paint during disassembly.
- Dismantle the original cover of the filler neck, possibly also the cabinet, if it is being changed as a whole.
- Remove dirt from the seating and mounting surfaces.
- Compare the old and new part side-by-side, especially the mounting, dimensional solution and guidance of moving parts.
- Sit the new part first on a clean surface and verify that it fits without tension and without the need for forceful seating.
- Install the filler neck box if it is part of the replacement, then properly seat the cap itself.
- Secure all attachment points so that it holds the part firmly but does not stress the plastic parts.
- Try opening and closing the lid several times in succession.
- Check the fit with the surrounding bodywork and whether the lid fits properly.
-
4) Post-assembly checks and function verification
- Verify smooth operation of opening and closing without stuttering.
- Check that the lid holds properly in the closed position after closing.
- Check that there is no excessive clearance or crossing of the part anywhere.
- After assembly, we recommend visually inspecting the surrounding area of the filler neck and the fastening of the cabinet.
5) The most common assembly mistakes + how to avoid them
- Exchanging a similar part – always compare the product codes and the shape of the attachment.
- Paint damage during assembly – work carefully and use appropriate disassembly tools.
- Insufficient cleaning of the contact surfaces – dirt can cause poor fit and inaccurate alignment.
- Overlooking cracks or tired grips – always check the overall condition of the used part before assembly.
- mechanical damage during refueling or careless handling,
- Hinge or latch breakage due to repeated use,
- minor accidents and contact with surrounding objects,
- aging of plastic parts and their brittleness,
- damage to paintwork and surface due to weather and normal use.
