Description
Right Side Exterior Mirror For Citroën C4 First Generation
Color EZR – Painted Gray Aluminium
Electrically Adjustable, Temperature Sensor
Passenger Door
7 Pins 5+2
This right side exterior mirror is a direct-fit replacement for Citroën C4 first generation vehicles and is commonly searched under product codes 8149ZV and 1608065580. Finished in EZR Gray Aluminium paint, the mirror is electrically adjustable and includes an integrated temperature sensor. Designed for professional garages and competent DIY enthusiasts, this unit restores correct mirror positioning and functionality after damage or electrical failure.
Technical Information
- Manufacturer: Stellantis (Citroën/Peugeot)
- Model: Citroën C4 (First Generation) — Right Side / Passenger Door
- Product Codes: 8149ZV, 1608065580, EZRC
- Additional Numbers: Connector 7 Pins (5+2)
Function And Features
The mirror provides side and rear visibility while allowing electronic adjustment from the cabin for safe lane changes and parking. The integrated temperature sensor can be used by vehicle systems (for example climate or mirror-heating logic) and the electrical drive enables precise mirror angle control. The 7-pin connector (5+2) supplies power and signal connections required by the motor, sensor and any additional functions.
Replacement Procedure
Basic Replacement Steps (General Guidance):
- Disconnect Battery Before Work: Disconnect the negative terminal to prevent short circuits when handling electrical connectors.
- Remove Interior Door Trim Or Mirror Cover: Carefully detach the trim panel or triangular cover to access the mirror mounting screws and electrical connector.
- Unplug Connector: Locate and unplug the 7-pin connector (5+2) from the mirror module.
- Remove Mounting Bolts: Unscrew the mirror fixing bolts and remove the old mirror from the door aperture.
- Install New Mirror: Position the replacement mirror, secure the mounting bolts to the manufacturer’s torque specification, connect the wiring harness, and refit the interior trim.
- Function Test: Reconnect the battery and verify electrical adjustment, sensor function and any heating/defrosting feature if applicable.
Installation Recommendations
- Use Appropriate Tools: Torx or hex bits are commonly required for door trim and mirror fasteners — check fastener type before starting.
- Protect Door Trim: Use trim removal tools to avoid breaking clips or scratching interior surfaces.
- Check Connector Condition: Inspect pins and plugs for corrosion or bent contacts and clean if necessary before reassembly.
- Follow Manufacturer Torque And Refit Sequence: Ensure correct bolt torque and clip engagement to avoid wind noise or water ingress.
Why The Part Commonly Fails
Most Failures Are Caused By Impact Damage (Collisions Or Parking Scrapes), Water Ingress Leading To Corrosion Of Connectors Or Motor, And Wear Of The Electric Adjustment Motor After Many Years Of Use. Glass Breakage From Stones Or Vandalism Is Also Frequent. Electrical Faults May Occur From Damaged Wiring Or Moisture Entering The Connector.
Notes On Compatibility
The Part Is Intended For Citroën C4 First Generation Vehicles And Is Frequently Searched By The Codes 8149ZV And 1608065580. Verify That The Connector Type (7 Pins 5+2) And Color Match Your Vehicle When Selecting Replacement Parts.
Recommendation For Professional Service
If The Mirror Contains Additional Functions That Require Calibration Or Integration With Vehicle Systems, Consider Professional Installation. For Typical Mechanical Or Electrical Replacement, An Experienced Technician Or Confident DIYer With Basic Tools Can Perform The Swap Following The Above Steps.
