Description
Left rear upper lamp light CITROEN C5 I and II Kombi
A socket with a light bulb can be purchased additionally
Side behind the driver
The left rear upper lamp for Citroën C5 I and II Kombi is suitable for cars where a damaged or non-functional rear light on the side behind the driver needs to be replaced. This is an original part from the PSA concern, which ensures the proper functioning of the rear lighting and corresponds to the homologation for operation on roads. Thanks to the precise shape and handles, mounting in the body is problem-free and the light fits well in its original storage.
This part is popular with auto mechanics and DIYers as it is a specific upper left rear light for the station wagon body version that often goes away due to age, vibration or minor accidents. When repairing the rear of the car, it is advantageous to use the original lamp to avoid deterioration of the car’s appearance or problems during the technical inspection due to inadequate lighting.
Technical information:
Manufacturer: PSA / Citroën / Peugeot
Model: Citroën C5 I Kombi, Citroën C5 II Kombi
Location: left rear upper lamp (side behind the driver)
Part type: rear combination light – upper part (combo body)
Product codes: 9637356380, 6350P9
Other numbers: NFP (designation of discontinued production in the original program)
Body: Station wagon
The lamp is intended exclusively for the rear part of the car on the driver’s side and does not fit body variants other than the station wagon. This minimizes the need for modifications during assembly and guarantees correct seating and sealing against the bodywork. The socket with the bulb can be purchased separately if the existing one is damaged or corroded – you can then fit the light with bulbs according to the vehicle manufacturer’s specifications.
Installation recommendations:
– Before disassembling the original lamp, disconnect the battery to avoid a short circuit when handling the electrical installation.
– Disassemble the inner covers in the luggage compartment in the place of the lamp and loosen the fastening screws or nuts of the old light.
– Carefully disconnect the electrical connector and check its contacts – in case of oxidation, clean the contacts with a suitable product.
– Before fitting a new lamp, check the seal around the light; if it is damaged or hardened, replace it to prevent water from entering the body.
– Insert the new lamp into the hole in the body so that it fits into the guide pins and tighten the fixing screws evenly, without over-tightening to avoid cracking the plastic.
– Connect the electrical connector, refit the internal covers and finally connect the battery.
– After installation, test all functions of the rear light (marking light, brake light, turn signal, possibly fog light or reversing light depending on the car’s equipment), and check that the light fits well with the body and there are no gaps anywhere.
