Description
Right Rear Inner Lamp For CITROËN C4 B7
Passenger Side
For Tailgate
This right inner rear lamp is a direct-fit replacement for the Citroën C4 II (C4 B7) tailgate, supplied under part references 9672155480 and 7453E5. It restores correct rear lighting appearance and function on the passenger side of the tailgate, making it a practical choice for professional workshops and DIY mechanics looking for a reliable, OE‑compatible lighting unit. Keywords: Citroën C4 II tailgate lamp, right rear inner lamp, 9672155480, 7453E5.
Overview
The unit fits into the tailgate inner panel on the passenger side and replaces the rear lamp assembly located in the tailgate. It is suitable for body repairs, accident recovery, or when the original lamp shows signs of damage or water ingress. Designed for easy replacement with basic workshop tools, it helps restore full lighting functions including position, brake, and turn light circuits where applicable.
Key Features
- Direct-fit design for Citroën C4 II (C4 B7) tailgate – passenger side.
- OE product codes referenced for quick cross-checking: 9672155480, 7453E5.
- Constructed to match factory mounting points and electrical connector layout.
- Suitable for garage technicians and competent DIY installers.
- Helps maintain correct rear light appearance and road safety compliance.
Technical Information
- Manufacturer: Citroën / Stellantis
- Model: Citroën C4 II (C4 B7) – Passenger Side, Tailgate
- Product Codes: 9672155480, 7453E5
- Additional Numbers: 74530000, 7453E4
Installation Recommendations
Basic replacement steps (typical procedure):
- Open the tailgate and remove the interior trim panel to access the lamp mounting screws/clips.
- Unscrew or release the retaining fasteners and carefully extract the lamp assembly from the tailgate aperture.
- Disconnect the electrical connector—inspect pins for corrosion or damage and clean if necessary.
- Fit the new lamp into the mount, secure the fasteners, reconnect the electrical plug and reassemble the trim panel.
- Test all lamp functions (position, brake, indicator, reversing if present) before handing the vehicle back to the customer.
Practical tips: Disconnecting the negative battery terminal is recommended when working on vehicle electrics to reduce the risk of short circuits. Use panel-safe tools to avoid damaging trim clips. Check the sealing surface and tailgate drainage to prevent future water ingress.
Most Common Failure Causes
- Water Ingress: Damaged seals or clogged tailgate drainage can allow moisture into the lamp, causing corrosion or lamp/module failure.
- Impact Damage: Rear-end collisions or loading incidents can crack the housing or break mounting tabs.
- Connector Corrosion: Moisture and road salt can corrode electrical contacts, causing intermittent or total loss of function.
- Bulb Or Module Failure: Depending on production variant the assembly may contain replaceable bulbs or integrated LED modules; both can fail over time.
- Wear And Fatigue: Repeated opening/closing of the tailgate and vibration can eventually loosen mounts or damage wiring.
Replacement is generally performed when the lamp shows visible damage, persistent electrical faults, or loss of required light functions. Typical fitment time for an experienced technician is approximately 30–60 minutes depending on trim complexity and access.
