Description
Bulb holder for right rear lamp for first-series Citroën C1 and Peugeot 107 2013. Functionality of the bulbs themselves is not guaranteed. Supplied with a piece of wiring.
The Right Rear Lamp Bulb Holder (Part No. 1607990780) is a practical replacement component for first-generation Citroën C1 and Peugeot 107 vehicles. Designed for professional garages and DIY mechanics, this unit provides the electrical contact and mechanical support for stop, tail and indicator bulbs in the right rear lamp cluster. Supplied with a length of wiring, it simplifies repairs where the original connector or short wiring harness is damaged. Including the correct part number in searches increases the chance of quick identification and fitment.
How It Fits And How To Replace
Replacement is straightforward for anyone with basic workshop tools. Typical steps:
- Disconnect the battery before starting the job to avoid short circuits.
- Access the rear lamp from the boot/bootlid: remove trim panels and the lamp retaining screws or clips.
- Unplug the existing socket from the lamp cluster and note the bulb positions (stop/tail/indicator).
- Remove the old holder from the lamp housing and fit the new holder. If necessary, splice the supplied wiring into the vehicle loom using correct connectors or heat-shrink joints.
- Refit the lamp, reconnect the battery and test all functions (stop, tail, indicator, reverse if applicable).
Technical Information
- Manufacturer: Stellantis (Citroën / Peugeot)
- Model: Citroën C1 (First Series), Peugeot 107 (First Series), 2013
- Product Codes: 1607990780
- Other Numbers: Not Available
Installation Recommendations
Always disconnect the battery before working on the lighting circuit. Ensure mating surfaces and contacts are clean and free of corrosion before installation. Use dielectric grease on the contacts to improve corrosion resistance and electrical reliability. When splicing the supplied wiring, use sealed heat-shrink connectors or solder and heat-shrink tubing to secure joints. Check the lamp housing for signs of water ingress or damaged seals and repair if needed to prevent premature failure of the new holder.
Most Common Causes Of Failure
Bulb holders in rear lamps typically fail due to moisture ingress causing corrosion of the contacts, heat cycling from bulb operation which can deform or melt plastic, vibration leading to cracked plastic or intermittent contacts, and electrical overloads or poor earth connections. Often the visible symptom is flickering lights, intermittent operation, or a circuit that fails under load. Lifespan varies with vehicle use and environment; in humid or salt-exposed conditions failures appear sooner.
