Description
Product Overview
This wiring harness with tail light sockets is designed specifically for the rear wing of the Peugeot 607. It provides secure electrical connections for the rear lamps and is supplied for both left and right sides with identical harnesses. The unit is referenced under product code 6534GS.
Features & Function
The harness routes power and signal circuits for the tail, brake and indicator lamp sockets mounted in the rear wing. It secures connectors, maintains correct polarity and ensures reliable contact under normal operating conditions, helping to preserve visibility and safety at night or in poor weather.
Common Failure Modes
Wiring harnesses can deteriorate over time due to moisture ingress and connector corrosion, mechanical stress or vibration that causes wire breakage, insulation wear, and occasional rodent damage. Connector contact wear or contamination can also lead to intermittent lighting faults.
Installation & Replacement
Replacement is straightforward for a trained technician or an experienced DIYer. Typical steps: disconnect the battery, remove the rear interior trim and tail light assembly, unplug the old harness from the lamp sockets and vehicle loom, install the new harness in the wing, reconnect all plugs and test every light function before reassembly. No special tools are normally required beyond standard hand tools; applying a small amount of dielectric grease to connector contacts helps reduce future corrosion.
Fitment & Recommendations
Direct-fit for Peugeot 607 rear wing applications. Both left and right sides use the same harness design. Always verify part numbers against the vehicle VIN and compare connector shapes and pin counts prior to fitting. Regular visual inspection of rear wiring and connectors can prevent unexpected light failures.
Technical Information
- Manufacturer: PSA Citroën Peugeot
- Model: Peugeot 607
- Product Codes: 6534GS
- Additional Numbers: NFP
