Description
Left rear inner lamp for the tailgate for PEUGEOT 406 COMBI. Without bulb holders; these can be purchased separately.
Product Overview
This left rear interior lamp is designed for the tailgate of the Peugeot 406 Combi (estate). It provides interior illumination of the load compartment and serves as a replacement lamp assembly for the left side of the boot lid. The unit is commonly searched under the code 6350H6 and is offered as an original-fit replacement for vehicles using the same part number.
Key Features
- Direct replacement for Left Rear Tailgate Interior Lamp on Peugeot 406 Combi
- OEM-fit style and mounting points for straightforward installation
- Sold without bulb holders/sockets — bulb holders must be purchased separately
- Ideal for professional fitters and DIY mechanics performing trunk/boot repairs
Compatibility
Compatible with Peugeot 406 Combi (Estate) models that use the corresponding left tailgate inner lamp part number. The product is commonly referenced by code 6350H6.
Installation
Typical replacement procedure for a trained mechanic or experienced DIYer:
- Open the tailgate and remove the interior trim panel (plastic clips and/or screws) to access the lamp assembly.
- Unclip the lamp housing from the tailgate and carefully unplug the electrical connector.
- If reusing the bulb holder, remove it from the old unit and fit it into the new lamp (note: bulb holder is not included with this item).
- Fit the new lamp assembly into the tailgate, reconnect the electrical connector, and secure the housing with its clips/screws.
- Test the lamp operation before reattaching the interior trim panel.
For safety, ensure ignition is off and avoid shorting wiring during installation; disconnect the negative battery terminal if required by workshop procedure or if you will be working near other vehicle electronics.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model(s): Peugeot 406 Combi (Estate) — Left Rear Tailgate Inner Lamp
- Product Codes: 6350H6 NFP
- Other Numbers: 6350H6
Installation Recommendations
- Use proper trim tools to avoid damaging trim clips and panels.
- If the vehicle shows signs of water ingress, inspect tailgate seals and drainage channels and repair as needed before installing the new lamp.
- Replace corroded connectors or bulb holders; a poor electrical contact can cause intermittent operation or failure.
- Test all lamp functions (interior illumination, any integrated sensors) after installation and before refitting trim.
Most Common Failure Reasons
- Moisture ingress and water leaks leading to corrosion of contacts or bulb holder failure.
- Cracked or damaged lens/housing from impacts or loading/unloading cargo.
- Corroded or brittle wiring and connectors, especially in older vehicles or where seals have failed.
- Bulb holder or bulb failures — note that this product is supplied without the bulb holder.
Notes
Searchable identifiers: 6350H6. Bulb holders/sockets are not included with this lamp and must be ordered separately if required.
