Description
Right Rear Lamp Light PEUGEOT 308 Hatchback. Without Bulb Sockets — they can be purchased separately: 1606959180. Passenger Side.
Product Overview
Replacement right rear tail lamp designed for Peugeot 308 Hatchback models. This unit delivers OEM-fit geometry and mounting points for a direct swap, restoring rear lighting functions including brake, tail, and indicator circuits (bulbs and sockets not included). Ideal for professional garages and DIY mechanics who need a reliable body part with correct fitment and finish.
Key Features & Benefits
- Direct Fit Replacement: Manufactured to match OE mounting points for quick installation.
- Complete Rear Lighting Functionality: Supports brake, tail, and indicator lamps (requires appropriate bulbs/sockets).
- Durable Construction: Designed to withstand vibration and road conditions typical for passenger vehicles.
- Cost-Effective Repair: Replace only the damaged lamp instead of entire rear assembly.
- Part Number Searchable: Commonly referenced by codes 9680425680 and 6351CV for easy lookup.
Compatibility & Fitment Notes
Fits Peugeot 308 Hatchback models (right rear / passenger side). Confirm the shape and connector location on the vehicle before installation. This lamp is supplied without bulb sockets; the socket assembly is available separately under part number 1606959180.
Technical Information
- Manufacturer: Peugeot (Stellantis)
- Model: Peugeot 308 Hatchback
- Product Codes: 9680425680; 6351CV; 6351.CV
- Additional Numbers: 1606959180 (Bulb Socket, Sold Separately)
- Position: Right Rear (Passenger Side)
- Included: Lamp Housing Only (No Bulb Holders / Bulbs)
Installation Recommendations
Recommended for installation by experienced technicians or competent DIYers. Typical replacement steps:
- Open the tailgate and remove the inner trim to access the lamp mounting area.
- Unscrew retaining nuts or remove clips holding the lamp in place.
- Carefully pull the lamp assembly out and disconnect the electrical connector.
- Fit the new lamp, ensuring the seal is correctly positioned to prevent water ingress.
- Reconnect the wiring harness, secure the lamp with original fasteners and test all lighting functions (tail, brake, indicator, reverse if applicable).
Use appropriate torque for fastening hardware and replace any damaged seals or clips. Clean mating surfaces and check connector pins for corrosion before reassembly.
Why This Part Fails Most Often
- Impact Damage: Rear collisions or minor bumps frequently crack or break the lamp housing.
- Moisture Ingress: Failed seals allow water to enter, causing condensation, electrical faults, or corrosion of contacts.
- Vibration And Fatigue: Long-term vibration can loosen mounting points or cause hairline cracks.
- Socket Or Bulb Issues: Burnt or corroded bulb sockets can lead to poor contact and intermittent lighting.
Practical Tips
- Always inspect and if necessary replace bulb sockets (part 1606959180) when fitting a new lamp to avoid future faults.
- Check seals and clean connector pins; apply dielectric grease to connectors to prevent corrosion.
- After installation, verify all light functions from both inside and outside the vehicle, and confirm proper alignment and sealing.
Final Notes
This lamp is a practical solution for restoring rear lighting on Peugeot 308 Hatchback vehicles. Use the listed product codes (9680425680, 6351CV) when searching for compatibility or spare parts to ensure a correct match.
