Description
Right rear light for PEUGEOT 307 SW from 2005. Without bulb holders, these can be purchased separately. Passenger side.
This original-style right rear lamp is a direct-fit replacement for Peugeot 307 SW estate models and is frequently searched by part numbers. It restores full rear signalling and lighting functionality, improves vehicle appearance after damage, and is suitable for professional workshops and DIY mechanics. The lamp is supplied without bulb sockets, allowing you to reuse original holders or fit new ones to match your preferred bulb types.
Features
- Direct-fit replacement for Passenger Side (Right) of Peugeot 307 SW.
- Includes complete lamp housing and lens; bulb holders not included.
- Exact fit to original mounting points for straightforward installation.
- Compatible with common part number references used in repairs and ordering.
- Restores brake, tail and indicator light functions (depending on vehicle wiring).
Technical Information
- Manufacturer: Stellantis (Peugeot)
- Model: Peugeot 307 SW (Estate) — Passenger Side (Right) — From 2005
- Product Codes: 9655768480, 9655768580, 6351X2, 6351X3
- Additional Numbers: 6351.X2, 6351.X3
Installation Recommendations
- Park vehicle on a level surface and switch off ignition. If preferred, disconnect the negative battery terminal to avoid short circuits while working on electrical connectors.
- Open the tailgate and remove the interior trim panel to access the rear lamp mounting nuts or bolts.
- Unscrew the fasteners and carefully pull the lamp assembly outwards to expose the wiring connector.
- Disconnect the wiring harness by releasing the connector clip, then remove the lamp from the vehicle.
- If reusing bulb holders, transfer them from the old lamp to the new unit. Fit new holders if required (holders are not supplied).
- Reconnect the wiring, test all light functions (tail, brake, indicator, reversing if applicable) before refitting trim, then tighten fasteners to the manufacturer’s torque recommendations.
- Avoid overtightening to prevent cracking the lens or deforming mounting tabs.
Most Common Failure Causes
- Water Ingress: Damaged seals or cracked lens can allow moisture into the housing, causing corrosion and electrical faults.
- Impact Damage: Rear collisions or minor bumps commonly crack the lens or break mounting tabs.
- Connector Corrosion: Oxidation of electrical contacts leads to intermittent lighting or failure.
- UV Degradation: Long-term sun exposure can fade or weaken the lens material.
- Bulb Or Holder Failure: Bulbs and holders wear out over time; note that bulb holders are not included with this lamp.
Notes
- Bulb Holders Not Included: This lamp is supplied without bulb sockets. You can reuse the original holders or purchase replacements separately.
- Frequently Searched By Part Numbers: Use the listed product codes when ordering to ensure quick matching.
