Description
Rear left fender tail light, driver’s side, for PEUGEOT 307 CC. The lamp has been resealed with silicone, does not fog up, and there is no risk of the plexiglass detaching.
This rear left tail lamp is intended for Peugeot 307 CC vehicles and carries original Stellantis/Peugeot part references. The unit has been professionally resealed with silicone to prevent moisture ingress, so the lens remains clear and the plexiglass is securely fixed. Ideal for mechanics and DIY enthusiasts looking for a direct-fit replacement by part number (714025600761 / 6350S3 / 6350X4). Note: The lens has lightened over time on this used unit; a new example is shown in the second photo.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 307 CC (Compatible with 307 Phase 1 and Phase 2 variants where applicable)
- Product Codes: 714025600761, 6350S3, 6350X4
- Other Numbers: 6350S3 | 6350X4 | 714025600761
Function And Features
Provides rear lighting functions including tail, stop and indicator (depending on vehicle wiring). The housing is supplied ready to fit with original mounting points and electrical connector. Resealed silicone bead reduces risk of condensation and water ingress, improving long-term reliability of the unit.
Installation Recommendation
General Replacement Steps:
- Disconnect the battery before starting any work on the lighting circuit.
- Access the lamp from the boot or inner wheel-arch by removing the trim or access cover.
- Unscrew the retaining bolts, carefully pull the lamp assembly out and disconnect the electrical connector.
- Fit the replacement lamp, reconnect the connector and test all lighting functions (tail, brake, indicator, reverse if applicable).
- Check sealing surfaces for cleanliness and apply additional silicone sealant if necessary to ensure watertight fitment.
- Refit trims and torque fasteners to manufacturer specifications where available.
Use proper tools, protect the painted surfaces and avoid scratching the lens during installation. Replace bulbs or socket inserts if signs of corrosion or wear are present.
Most Common Failure Reasons
- UV Exposure And Lens Fading: Prolonged sunlight can lighten or yellow the lens over time.
- Sealing Damage: Cracked or degraded seals allow moisture, causing fogging or electrical faults.
- Impact Damage: Rear collisions or stone chips can crack the lens or housing.
- Corroded Contacts Or Bulb Holders: Moisture or salt leads to poor electrical contact and intermittent function.
- Wiring Harness Damage: Chafing or connector damage from previous repairs or accidents.
Notes For Buyers
This lamp is commonly searched and ordered by its part numbers (714025600761, 6350S3, 6350X4). It is supplied resealed to prevent condensation; however, inspect mounting tabs and connector condition during fitment. Replace bulbs or connectors if necessary to ensure reliable operation.
