Description
Right rear lamp for the tailgate of PEUGEOT 307 CC. The lamp is used, solid, repaired with silicone, does not fog up. Passenger side.
Product Overview
Used right rear tailgate lamp for Peugeot 307 CC, ideal for mechanics and DIY restorers who search by part number. The housing has been structurally repaired and sealed with silicone, preventing internal condensation. This assembly restores the tailgate lighting functions and fits the passenger side of the lifting tailgate.
Compatibility
Fits Peugeot 307 CC models. Frequently referenced under OEM and aftermarket codes 964130008JE, 714025600801 and 6351S4. Check the vehicle model designation 307 CC (coupe cabriolet) and mounting position: right / passenger side tailgate lamp.
Technical Information
- Manufacturer: Peugeot (Stellantis)
- Model: Peugeot 307 CC (307 I / 307 II compatibility to be verified by matching part numbers)
- Product Codes: 964130008JE
- Other Numbers: 714025600801, 6351S4
Function And Symptoms
This rear tailgate lamp assembly provides the exterior lighting functions mounted in the tailgate, including tail/brake/indicator and, depending on version, reversing or position functions. Typical signs of a failing or damaged unit are visible cracks in the housing, water ingress or condensation, intermittent or non-functioning lamps, and damaged mounting tabs that prevent secure fitment.
Common Causes Of Failure
The most frequent causes are mechanical impact (minor collisions or closing the tailgate against an obstruction), degraded seals allowing moisture ingress, UV and heat-related aging of the plastic, corrosion of bulb sockets or connector pins, and snapped mounting clips from repeated use. In this specific unit the housing was repaired with silicone and does not show fogging.
Replacement Procedure
- Switch the ignition off. For safety when working with electrical connectors consider disconnecting the negative battery terminal.
- Open the tailgate and remove the interior trim to access the lamp fasteners and electrical connector.
- Disconnect the electrical connector and release any locking tabs on the harness.
- Remove screws or plastic clips securing the lamp assembly and carefully extract the lamp from the tailgate aperture.
- Inspect the wiring, bulb holders and sealing surface for corrosion or damage. Replace broken clips or seals as needed.
- Fit the replacement lamp, secure fasteners, reconnect the electrical connector and test all functions (tail, brake, indicator and any additional lamps).
- Reinstall trim and check alignment and sealing to prevent future water ingress.
Installation Recommendations
Use correct fasteners and replace any brittle clips. Clean connector pins and apply a light dielectric grease to improve contact reliability. Ensure the mating surface is clean and the seal is intact; if previous damage required silicone repairs, verify that the silicone used is automotive grade and applied only to restore sealing. After installation test all lighting functions and the tailgate closing operation.
Why Choose This Unit
This used lamp is a cost-effective replacement for a functional tailgate light where the housing has been repaired and sealed to eliminate condensation. It is well suited for professional workshops and experienced DIYers who need a direct-fit rear lamp for the passenger side of Peugeot 307 CC and who search by part numbers 964130008JE, 714025600801 or 6351S4.
Tips For Longevity
- Ensure proper sealing after installation and replace degraded gaskets.
- Avoid closing the tailgate onto obstacles and check alignment periodically.
- Keep electrical connectors clean and protected from moisture.
