Description
Left rear lamp for PEUGEOT 307 hatchback up to 2005
Without bulb holders
Driver’s side
Original part
Product Overview
This left rear combination lamp is an OEM replacement designed for the Peugeot 307 hatchback models produced up to 2005. The unit is supplied without bulb holders or bulbs, so bulbs and sockets must be transferred from the original assembly or purchased separately. Many customers search by the product code 6350P4 when looking for this part.
Compatibility
Fits: Peugeot 307 Hatchback (Front Facelift / Pre‑Facelift variants produced up to 2005). Driver’s side (left rear). Confirm fitment by model year and body style before ordering.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 307 Hatchback (up to 2005)
- Product Codes: 6350P4
- Other Numbers: –
Features And Function
The rear lamp is a combination unit that provides tail light, stop (brake) light and indicator functions; depending on vehicle specification it may also accommodate a reversing lamp. The lamp housing includes the lens, reflector and mounting points. As supplied, bulb holders and bulbs are not included and must be installed separately.
Replacement Procedure
Access the lamp from inside the boot by removing or folding back the inner trim to reach the mounting fasteners. Unfasten the retaining nuts or bolts, carefully withdraw the lamp assembly and disconnect the wiring connector. Transfer the bulb holders or fit new ones, then fit the new lamp in reverse order and verify correct operation of all light functions. Take care not to overtighten fasteners and ensure the unit seals correctly against water ingress.
Why This Part Typically Fails
Rear lamps rarely fail electrically on their own. Common causes for replacement include impact damage from minor collisions, cracked or scratched lenses, broken mounting tabs due to vibration or ageing plastics, and water ingress that leads to corrosion of contacts or bulb holder damage. UV exposure and thermal cycling over many years can make plastic parts brittle and more prone to cracking.
Installation Recommendations
- Disconnect the vehicle battery before beginning work to avoid short circuits and to protect vehicle electronics.
- Inspect and, if necessary, replace bulb holders and bulbs when installing the lamp, since this unit is supplied without them.
- Check and clean the wiring connector and contacts; apply dielectric grease to electrical contacts to reduce corrosion risk.
- Ensure all sealing surfaces are clean and that the lamp sits flush to prevent moisture entry. Replace any damaged gaskets or seals.
- After installation, verify operation of tail, stop, indicator (and reversing, if applicable) lights before closing the boot.
